Simulating a volcanic eruption
Transcript of Simulating a volcanic eruption
How to make a model volcano
MaterialsA plastic bottle, 33 cl.Two small glasses of
water.A small glass of vinegar.Baking soda.A funnel .A piece of card or
cardboard.Plasticine in different
colours.White glue.
Make a cone with a piece of card and cut off the tip.
Place the plastic bottle inside the cone.
Glue the bottle and the cone onto the
cardboard.
Cover the cone with plasticine, using different colours.
Leave the top of the volcano open.
Use the funnel to pour the water and the vinegar into
the botle.
Add a spoonful of baking soda and watch what
happen.
How does it work?A Volcano is produced over thousands of years as heat a
pressure build up. That aspect of a volcano is very difficult to recreate in a class experiment. However this volcano will give you an idea of what it might look like when a volcano erupts flowing lava.
This is a chemical reaction: The baking soda is sodium bicarbonate. The vinegar is weak acetic acid. The two chemicals mix together to form carbon dioxide gas. Gases and molten rock escape from a real volcano in much the same way as the carbon dioxide and water-based lava are forced out of the model volcano.
You can recharge the volcano by adding more baking soda and vinegar so you can have as many eruptions as you like.
•I hope you have enjoyed learning how to make a baking soda and vinegar volcano.