Prof. Steven S. Saliterman Introductory Medical Device ...SOLIDWORKS Inspection CircuitWorks...
Transcript of Prof. Steven S. Saliterman Introductory Medical Device ...SOLIDWORKS Inspection CircuitWorks...
-
Prof. Steven S. Saliterman Introductory Medical Device Prototyping
Department of Biomedical Engineering, University of Minnesota http://saliterman.umn.edu/
-
Prof. Steven S. Saliterman
• Launch SolidWorks • Select Resources to
open the Task Pane. • Select Tutorials
-
Prof. Steven S. Saliterman
Open Lofts
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
Triad
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
-
Prof. Steven S. Saliterman
Topics Covered in this exercise: ◦ Creating parallel planes. ◦ Sketching on specific planes and copying from one
plane to another. ◦ Lofted bose-base feature and connecting profiles. ◦ Flex feature, moving trim planes and bending
material
Slide Number 1Starting The TutorialsSelect Basic TechniquesHammer HeadCreating a Parallel PlaneAdding Two More PlanesSketch on Plane 2Circle Coincident with VerticesCopy-Paste Sketch from Plane 2 to 3Lofted Bose-Base FeatureSolid ModelCreating Plane 4Sketch on Plane 4Lofted Bose-Base Connected ProfilesFlex Feature and Trim PlanesMoving Material Between Trim PlanesFinished Hammer HeadSummary