Futuro FuturoFuturo FuturoRANGE HOODINSTALLATION MANUALMODEL: RECANO ISLAND(40” & 60” VERSIONS)

NOTE: PRIOR TO INSTALLATIONPlease inspect range hood visually,

as well as connect it to power supplyand test its operation.

RecommendedInstallation Height1

26” - 28”from cooktopto bottomof hood

NOTE: Inch dimensions are approximate, and given for reference / convenience only.Always measure the actual items on-site and make drilling / cutting marks according toactual materials & measurements.

MOUNTING PLATE DIMENSIONS

NOTE: Inch dimensions are approximate, and given for reference / convenience only.Always measure the actual items on-site and make drilling / cutting marks according toactual materials & measurements.

MOUNTING PLATE SPACING

2

3

105m

m (

4 1/

8”)

105m

m (

4 1/

8”)

40” WIDE VERSION 60” WIDE VERSION

901mm (35 1/2”)

1300mm (51 3/16”)

1401mm (55 1/8”)

800mm (31 1/2”)

105m

m (

4 1/

8”)

98mm (3 7/8”)

49m

m (

2”)

49m

m (

2”)

15mm(9/16”)

68mm (2 11/16”)

68m

m (

2 11

/16”

)

1.) Drill holes in ceiling / joists / plywood, to match holes in mounting plates.2.) Attach mounting plates to ceiling, using the provided screws & washers.NOTE: Concrete / masonry ceilings ONLY - use anchors as needed.

ATTACH MOUNTING PLATES TO CEILING4 1.) Locate cover panels on top of range hood.2.) Remove screws holding panels in place.3.) Remove panels.

REMOVE PANELS FROM HOOD5

1.) Locate the power cord.2.) Thread power cord through hole inrange hood body, as shown.

PREPARE POWER CORD6 1.) Slide horizontal trim plate onto vertical rod covers.

2.) Slide rod covers onto threaded rods.3.) Secure bottoms of rods with brackets, washers and nuts.

ASSEMBLE SUPPORT STRUCTURE7

Thread the power cord through the brackets,through the provided hole next tocenter screw, and run it verticallythrough the support rail, as shown.

BRING POWER CORD TO CEILING8

Connect the power cord to the power linein the ceiling, in accordance with yourlocal building codes.

CONNECT POWER CORD TO POWER LINE9

1.) Raise hood body and slide mounting screws intomatching holes on support brackets.2.) Secure hood to both bracket with screws.

ATTACH HOOD TO SUPPORT BRACKETS10

1.) Replace the cover panels(that were removed in Step 5.)2.) Secure panels with original screws.

REPLACE COVER PANELS

Adjust the vertical level with screws.LEVEL TOP BRACKETS

1112

1.) Raise the trim plate to the upper brackets.2.) Secure trim plate with screws, as shown.

Check the functions of the range hoodto ensure proper operation.

ATTACH TRIM PLATE

CHECK RANGE HOOD

13

15

Install the supplied filterpackage, as shown.

INSTALL FILTER PACK

14