CITROEN C5 (2008 - 2011) MKi + CK (EN_US).pdf

C5

This sheet is designed to help you with the installation of a Parrot product and is provided purely for information purposes. The installer is solely responsible for any installation carried out in accordance with the instructions in this sheet and for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA, a French Société Anonyme (Public Limited Company) Registered on the Paris Trade and Companies Register under No. 394 149 496 Reproduction not permitted without authorisation from Parrot SA. Images not contractually binding.

C5

Installation manual: Parrot MKi + Parrot CK3100 range

The brand name CITROËN C5 and the CITROËN logo are the property of CITROËN AUTOMOBILES. This document is only valid for the vehicle model C5® year 2008 to 2011, excluding all other models in the same range and excluding later modifications made to the vehicle by the manufacturer. The Parrot brand name and logos are the exclusive property of Parrot SA.

C5


Accessories required

Disassembly 20min

Kit installation 30min

Refitting 20min

Testing 15min

Total 1h25min

YES ACC wire

NO ISO

YES UNIKA

FRONT SPEAKER TEL mode

ALL MUSIC mode

Fitting time / Main features

Tools

- TORX screwdriver

- Multimeter or Test lamp

- Hose clamp

- Electrical tape

- Round file (or a knife)

Kram ref. Dealer ref.

CK range 86 165 9706AP

MKi range 84744 9706AT

Photos not contractually binding

CK range MKi range

Updating

Plastic trim removal tools FACOM / BERNER

FACOM Sleeve DX-25 (n°4 spanners)

To get the most out of your hands-free kit we recommend that you update your software regularly. The update procedure can be found at

www.parrot.com/usa/support/downloads

“Quick Connect harness references available at http://certified.parrot.com/faisceaux_US.php"

http://www.parrot.com/uk/support/downloads

http://certified.parrot.com/faisceaux_US.php

C5


Disassembly

C5


Disassembly 1 / 2

Insert the removal tools into the slots on each side of the radio.

Unclip, pull and lift the radio disconnecting the antenna

connector.

Using the plastic trim tools, unclip and remove the centre console

panel. (Do not disconnect it)

Using the plastic trim tools, unclip the dashboard panel.

1

3

2

4

5 6

Remove screw 1. Followed by screws 2 and 3.

1

2 3

C5


Disassembly 2 / 2

Using the plastic trim removal tools, unclip the dashboard panel by pulling

firmly upwards, then unplug the connectors.

Using the plastic trim tools, unclip the clip located on the left side of

the dashboard.

Open the storage compartment to the left under the steering

wheel.

Push the tabs in and unclip the storage compartment.

7

9

8

10

11

Remove the door seal on the driver’s side.

C5


Using the plastic trim tools, run the cable along the side of the panel towards the windscreen.

Microphone feeding 1 / 2

Glue the bracket (supplied) to the left of the cabin light panel, after

cleaning the surface.

Using the plastic trim tools, run the cable under the headliner

towards the driver's side windscreen post.

Run the cable replacing the seal on the driver's side door.

1

3

2

4

5 6

Pass the cable into the dashboard on the left side.

Run the cable under the steering wheel and attach with wire ties.

C5


Microphone feeding 2 / 2

Run the cable towards the centre console .

7

C5


Feeding the accessory cable

Using a guide, feed the cable through the hole towards the

centre console.

Be careful to leave enough length.

1 2

C5


ISO adapter

Fitting the hands-free system 1 / 2

Connect the adaptor (86165/9706AP for the CK or the 84744/9706AT for the Mki) to the

original connector. Connect all of the wires to the blue box as shown in the diagram below.

Test before reinstalling then slide the assembly into the bottom housing of the central console.

(Located under the storage compartment.)

1

C5


Fitting the hands-free system 2 / 2

Pass the cable through the display hole towards the radio.

Stick the screen bracket to the top left corner of the dashboard, after

carefully cleaning the surface.

Clip the dashboard panel back on by reconnecting the connectors. (Make sure that you DO NOT cut

the cable.)

2

4

3

!

C5


Testing

Before refitting the system, switch the kit on using the ignition (or by starting the car). By pushing the central knob

of the remote control, check:

1 - That the menu is displayed on the screen. (Language or iPod.) 2 - That the system can be muted. (Click in the blue box.) 3 - That there is no sound coming from the speakers. 4 - That the sound from the voice menu is coming out of the front speakers. 5 - Then turn off the ignition, check that the kit switches off and that the "goodbye" message appears on the screen. (If this fails, reverse the fuses on the kit's wiring harness.) 6 - Pair a telephone with the kit and make a call. (Check that both the microphone and the kit are working.)

C5


Reassembly

Refit the system using the following procedure: 1 – Re-place screws 1, 2 and 3 in the dashboard panel and clip the strip back on. 2 - Clip the centre console cover back on. 3 – Re-install the radio reconnecting the adaptor and the antenna. 4 – Re-fit the storage compartment under the steering wheel. 5 – Re-fit the panel on the left-hand side of the dashboard.

CITROEN C5 (2008 - 2011) MKi + CK (EN_US).pdf

Documents

Transcript of CITROEN C5 (2008 - 2011) MKi + CK (EN_US).pdf