Case Study saw-/ shaving mill Supplied PST Spiral Conveyors Material Wood shavings, sawdust Capacity...
1
Name of project Holmen Braviken Sawmill Location Norrkoping, Sweden Equipment Supplied PST Spiral Conveyors Material Wood shavings, sawdust Capacity Peak 400 m³/h Maximum particle size 20x20x20mm Number of conveyors 3 Commissioned October 2011 Plåt & Spiralteknik I Torsås AB Ramsågsgata 8 385 34 Torsås Sweden Mail: [email protected] Phone: +46 (0)486 456 50 Web: www.pst.se Handling wood shavings and sawdust from shaving to barn The installation is a V-system with a 18m long feeder, lo- cated underneath 3 cyclones with rotary valves. The feeder is located on ground level and attached at the bottom of a vertical conveyor that lifts the material 10m. The vertical conveyor feeds the top conveyor from below. The top con- veyor is installed above the roof of the barn with several outlets. When the barn is filled up to the first conveyor out- let, the second conveyor outlet will empty the conveyor and so on. The top conveyor is in total 36m long. The system is designed to take on a wide range of wood shavings and sawdust with ATEX 3D internal at a capacity up to 400m³/h. Frequency inverters are installed for the possi- bility of adjusting the speed for different recipes and save the wear liner by not running the conveyors empty. Case Study saw-/ shaving mill
Transcript of Case Study saw-/ shaving mill Supplied PST Spiral Conveyors Material Wood shavings, sawdust Capacity...
Name of project Holmen Braviken Sawmill
Location Norrkoping, Sweden
Equipment Supplied PST Spiral Conveyors
Material Wood shavings, sawdust
Capacity Peak 400 m³/h
Maximum particle size 20x20x20mm
Number of conveyors 3
Commissioned October 2011
Plåt & Spiralteknik I Torsås AB
Ramsågsgata 8
385 34 Torsås
Sweden
Mail: [email protected]
Phone: +46 (0)486 456 50
Web: www.pst.se
Handling wood shavings and sawdust from shaving to barn
The installation is a V-system with a 18m long feeder, lo-
cated underneath 3 cyclones with rotary valves. The feeder
is located on ground level and attached at the bottom of a
vertical conveyor that lifts the material 10m. The vertical
conveyor feeds the top conveyor from below. The top con-
veyor is installed above the roof of the barn with several
outlets. When the barn is filled up to the first conveyor out-
let, the second conveyor outlet will empty the conveyor and
so on. The top conveyor is in total 36m long.
The system is designed to take on a wide range of wood
shavings and sawdust with ATEX 3D internal at a capacity up
to 400m³/h. Frequency inverters are installed for the possi-
bility of adjusting the speed for different recipes and save
the wear liner by not running the conveyors empty.
Case Study saw-/ shaving mill
