Dr Simin Nasseri, SPSU Tutorial: Flange Chapter 1 Dr Simin Nasseri, SPSU Copyright of Howard and...

Post on 06-Jan-2018

223 views 0 download

description

Dr Simin Nasseri, SPSU Geometry of Flange INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Transcript of Dr Simin Nasseri, SPSU Tutorial: Flange Chapter 1 Dr Simin Nasseri, SPSU Copyright of Howard and...

Dr Simin Nasseri, SPSU

Tutorial: Flange

Chapter 1Dr Simin Nasseri, SPSU

Copyright of Howard and Musto, 2009

Dr Simin Nasseri, SPSU

Tutorial Learning Objectives

• Become familiar with the SolidWorks part modeling environment

• Use these features: extruded boss/base, extruded cut, circular pattern, fillet, and chamfer

• Learn how to create a new plane• Learn to consider the design intent when planning a

model

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Geometry of Flange

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 1 – Extruded Base

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 2 – Construction Plane

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 3 – Extruded Boss

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 4 – Extruded Cut

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 5 – First Bolt Hole

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 6 – Circular Hole Pattern

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 7 - Fillets

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Feature 8 - Chamfer

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Design Intent – Planning the Model

• Example: Creation of the construction plane to allow draft on the extruded base

• Design intent is the consideration of the end use of a part, and possible changes to the part, when creating a solid model.

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Dr Simin Nasseri, SPSU

Design Intent – Selecting a Modeling Technique

• When adding the fillets, they can be added in one step or in three separate steps

• If you want to be able to change all three simultaneously, use the first method

• If you want to be able to change each fillet individually, use the second method

• Always keep in mind the intended use and possible modifications when considering how to create the model

INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009