Statics (MET 2214) Prof. Simin Nasseri Friction MET 2214 Part 1.
Dr Simin Nasseri, SPSU Tutorial: Flange Chapter 1 Dr Simin Nasseri, SPSU Copyright of Howard and...
13
Dr Simin Nasseri, SPSU Tutorial: Flange Chapter 1 Dr Simin Nasseri, SPSU Copyright of Howard and Musto, 2009
-
Upload
rose-glenn -
Category
Documents
-
view
223 -
download
0
description
Dr Simin Nasseri, SPSU Geometry of Flange INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Transcript of Dr Simin Nasseri, SPSU Tutorial: Flange Chapter 1 Dr Simin Nasseri, SPSU Copyright of Howard and...
Dr Simin Nasseri, SPSU
Tutorial: Flange
Chapter 1Dr Simin Nasseri, SPSU
Copyright of Howard and Musto, 2009
Dr Simin Nasseri, SPSU
Tutorial Learning Objectives
• Become familiar with the SolidWorks part modeling environment
• Use these features: extruded boss/base, extruded cut, circular pattern, fillet, and chamfer
• Learn how to create a new plane• Learn to consider the design intent when planning a
model
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Geometry of Flange
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 1 – Extruded Base
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 2 – Construction Plane
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 3 – Extruded Boss
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 4 – Extruded Cut
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 5 – First Bolt Hole
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 6 – Circular Hole Pattern
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 7 - Fillets
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Feature 8 - Chamfer
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Design Intent – Planning the Model
• Example: Creation of the construction plane to allow draft on the extruded base
• Design intent is the consideration of the end use of a part, and possible changes to the part, when creating a solid model.
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
Dr Simin Nasseri, SPSU
Design Intent – Selecting a Modeling Technique
• When adding the fillets, they can be added in one step or in three separate steps
• If you want to be able to change all three simultaneously, use the first method
• If you want to be able to change each fillet individually, use the second method
• Always keep in mind the intended use and possible modifications when considering how to create the model
INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009
