Download - HV Probe NAT 111 4018 HV Reference cableAT 111 4056

Objednací číslo AT 505 5001

ATAL spol. s r.o. Lesní 47, Tábor - Horky, 390 01, Czech Republic Phone: +420 381 251 791, Fax: +420 381 253 043

e-mail: [email protected]; web: http://www.atal.cz

HHHVVV PPPrrrooobbbeee NNN ............................................................................................................AAATTT 111111111 444000111888 HHHVVV RRReeefffeeerrreeennnccceee cccaaabbbllleee.....................................................................AAATTT 111111111 444000555666

„HV probe N“ is used for measuring of the high voltage on the spark plugs by fitting the vehicle HV cable.

Option for Multi-Diag Scope

Multi-make Diagnostics Reference AT 111 4018, AT 111 4056

HV-probe-N-prospectus-en.doc The right is reserved to change this document (text and photos) ref.P111 0318

29.6

.201

1

During measuring on HV cables, when is required measuring of flashover voltage, is necessary insert the “High-voltage reference cable” between ignition cable and spark plug. At this „HV Reference cable“ then put „HV probe N“ (see figure below).

Measurement of high voltage on one cylinder with a high voltage cables with „HV probe N“

and „HV Reference cable“

Ground High Voltage probe N

High Voltage probe N

High Voltage Reference cable

High Voltage cable

Technical parameters HV probe N - AT 111 4018 HV probe C1 - AT 111 4017

±10% z MV ±15% z MV

Measurements of the High Voltage reference cable AT 111 4056

High voltage Voltmeter in oscilloscope

HV probe N - AT 111 4018 HV probe C1 - AT 111 4017

0 ... 25 kV 0,1 kV

±20% z MV ±30% z MV Measurement of the commonly used high-voltage cables

MV: measured value

Ground High Voltage probe N

High Voltage probe N

High Voltage cable

Measurement of high voltage on one cylinder with a high voltage cables with „HV probe N“