815.399.0001 outside the U.S.A. antel@antelinc.comINTERNATIONAL, INC.

33

Omnidirectional Antenna

Mechanical specificationsLength

BCD-80010, BCD-80610 & 82510Overall 3445 mm 136 inRadome 2945 mm 116 in

BCD-87010Overall 3393 mm 134 inRadome 2893 mm 114 in

Diameter 65 mm 2.6 in

Weight 12 kg 26.5 lbs

Wind area 0.22 m2 2.43 ft2

Wind loadat 50m/s 351 N 79 lbs

Support pipe

Aluminum alloy diameter 70 mm(2.76 in) length 500 mm (19.7 in).

Antenna consisting of aluminum alloy.Dipoles covered by a polyurethanepainted fiberglass radome. Invertedmodels available.

Electrical specificationsFrequency range

BCD-80010 806-900 MHzBCD-80610 806-941 MHzBCD-82510 825-960 MHzBCD-87010 870-960 MHz

Impedance 503) Connector N,NE,DIN,

E DIN or EIA1) VSWR ,21.43:1

Polarization Vertical1) Gain 10 dBd2) Power rating 500 W1) Half power angle

H-plane 360E-plane 7

1) Lobe tilt 1.251) Null fill 5%

Lightning protection Direct groundSee pages 37 & 38 for lobe tilt and nullfill combinations.

BC

D-8

0010/80610/8

2510/8

7010

BCD-80010/80610/82510/87010

Horizontal

Vertical

Radiation-pattern(at mid-band)

270 280290250

300240

230

220

210

200

310

320

330

340

190

180

350

0

170

160

10

20

150

140

130

120110 70

100 8090

60

50

40

30

-5 -10 -15 -20 -25

260

-30 -35 -30 -25 -20 -15 -5-10-35

270 280290250

300240

230

220

210

200

310

320

330

340

190

180

350

0

170

160

10

20

150

140

130

120110 70

100 8090

60

50

40

30

-5 -10 -15 -20 -25 -30 -25 -20 -15 -5-10

260

-35-30 -35

Antels unmatched antenna design includes:

A four-channel extruded aluminum frame running the entire length of the antenna.

Brass feedlines - No high-loss coaxial cable.

Feedlines connected by threaded holes, nuts & bolts - No solder joints.

Air as insulation. A unique radome with interlocking fiber

glass applied both horizontally and vertically for maximum strength.

Every Antel antenna is under a five-yearlimited warranty for repair or replacement.

Standard and Inverted ModelsAvailable.

1) Typical values.

2) Power Rating limited by connector only.

3) NE indicates an elongated N Connector.E DIN indicates an elongated DIN connectorEIA indicates a 7/8" EIA Flange.

Improvements to mechanical and/or electrical performance of the antenna may be made without notice.

Radiation patterns for all Antel antennasare measured with the antenna mount-ed on a fiberglass pole.

Tabulated Data is available in the following formats: ASCII, Granet, LCC/Anet, Lucent, Motorola, Planet, and WIZARD.

*ANTL-1000 BCD/BCR 26-49 2/3/00 10:29 AM Page 9