WindO/I-NV2 version 4.62 (AO v1.82)

Think Automation and beyond…

WindO/I-NV2 version 4.62(AO v1.82)

New Features

10/19/2012


Overview

Support New Drivers/Protocols New Recording Functions Other Improvements

– Visible / Invisible of functional parts or objects– Alarm Log (increased number of blocks)– Change Target PLC IP Address on OI Touchscreen– Increased Refreshing time of web page (Execution time)– User Communication via Ethernet– Conversion Update– Message Alert is added when selecting USB for

communication using HG2G-5ST.


New Protocols

Emerson FloBoss 107 Series– ROC Protocol

– Mainly for US market

– Emerson FloBoss 107 controllers are widely used in Oil and Gas industries

– Applicable to the following OI Touchscreen 5.7” HG2G-5S/-S & HG2G-

5FT22TF 8.4” & 10.4” HG3G Series 12.1” HG4G Series

YASKAWA MP2000 Series (Ethernet)

Fuji MICREX-SX (Serial / Ethernet)


Recording Functions

Video and Audio can be recorded– Event Trigger Recording

Max. 30 seconds 15 seconds before

and after It functions globally

– REC button/command Max. 30 seconds Must be triggered on that

specific screen where button/command placed


Improvements Visible/Invisible Parts

– This is supported by most of functional Parts.

– Part can be shown or not shown base on Visible Condition configure in Part Properties

– Applicable to High-Performance OI Touchscreen only


Improvements

Alarm Log– Increased the number of blocks

from 64 to 128 (for Word device only).

Data Storage Area Management (for Alarm Log)

Basic Series HG2G-S/5S: 5520 points (maximum amount of data storage area)

High Performance Series HG2G-5FT22TF, HG3G/HG4G: 11,660 points


Improvements

Host Interface IP address can be changed via OI Touchscreen– Current limitation

Host Interface IP address needs to be configured using WindO/I-NV2 software

– Using OI Touchscreen System Mode, host interface IP address can be changed

– Applicable to HG2G-S/-5ST/-5FT, HG3G, and HG4G All PLCs with Ethernet 1:N communication driver


Improvements

How to change Host Interface IP Address:1. Press and hold top-left corner for 3 or more seconds

2. Press System Mode Offline

3. Press Initial Setting Communication I/F Host IP Address

4. Enter Station No. and press the ENT key

5. Change the IP Address and press the ENT key

6. Press SAVE button


Improvements Web Page Refreshing Time

– Current Limitation Web page is refreshed constantly This creates problem for customers who use our OI

Touchscreen with cellular modem where data is being consumed

– Users now can set the refreshing rate

– Max. of 5 seconds (5000ms) can be set


Improvements

Enhancement of User Communication

– Support User Communications using Ethernet interface

Conversion Update

– If “Zooming Conversion “ is selected, it will automatically adjust the registered text and coordinates of the screens (i.e. Overlay Screens, Goto Screen Buttons)


Improvements

Warning Dialog when selecting USB for communication with HG2G-5ST models

WindO/I-NV2 version 4.62 (AO v1.82)

Documents

Transcript of WindO/I-NV2 version 4.62 (AO v1.82)