Slide 1

Welding Tools

Slide 2

Hacksaw Cutting device used to physically cut metal by hand. Takes time and effort to complete.

Slide 3

Bandsaw Used to cut metal Much faster and easier than hacksaw. Can cut through large pieces of metal with ease.

Slide 4

Metal Sheer Can be used to shear really large pieces of metal. Uses hydraulic pressure to cut metal. Dangerous machine

Slide 5

Metal File Used to file down and smooth off rough edges from metal. Hand tool Takes time to finish job

Slide 6

Drill Press Used to drill precise holes through metal. Can be used for big or small pieces of metal. Work must be clamped down properly.

Slide 7

Drill Hand Tool Used to drill holes through metal by hand. Usually used for smaller pieces of metal May not be as precise as using a drill press

Slide 8

Hammers Numerous types Extremely useful in welding and metal work.

Slide 9

Ball peen hammer Used for tapping things into place and shaping metal

Slide 10

Claw Hammer Used to drive nails as well as used to tear down wood and other fastners

Slide 11

Soft faced hammer Used in delicate situations where the face of the work does not need to be damaged

Slide 12

Chipping hammer Used to scrape slag from metal. Also sometimes called a slag hammer.

Slide 13

Vice grips Designed to apply clamp pressure and have large gripping teeth.

Slide 14

Cold Chisel Cutting tool used to shear bolts, pins, rivets, rods, and other metals. Always use safety glasses when using.

Slide 15

Grinder Used to clean metal, knock away impurities, smooth burrs and sharp places..etc

Slide 16

Wire Brush Used to clean slag away from metal. Used after you finish cleaning with the slag hammer.

Slide 17

Tongs Used to pick up metal Keeps hot metal from touching your hands.

Slide 18

Punches Many different types. Each one has a specific use.

Slide 19

Center punch Used to make depressions into metal before being drilled.

Slide 20

Prick punch and Pin punch Used to make very small depressions before using the center punch Used for driving straight pins, tapered pins, and roll pins in and out of holes.

Slide 21

Vise Mechanists vise is useful for holding parts that we need to work on. Can also be used as an aide to bend metal.

Slide 22

Oxyfuel torch Used to cut and pierce metal Uses a mix of oxygen and acetylene gas to cut or pierce Safety precautions must be taken

Slide 23

Plasma cutter Uses air pressure to cut through metal Makes a cleaner cut than using a torch

Slide 24

Striker Used to make a spark that will light the torch. Causes a spark by pushing the flint across the striker.

Slide 25

SMAW Welder (Stick Welder) Shielded Metral Arc Welder Use electrical current to create arc to be welder with. Must have electrode holder, ground clamp, and welding rod.

Slide 26

MIG welder Metal Inert Gas Also known as wire welding Can run off of electricity or off of argon gas Does not reqiuire a welding rod One of the easiest methods to figure out

Slide 27

TIG Welder Looks similar to a MIG welder but uses 100% Argon as a shielding gas. Much more complicated method of welding (requires the use of both hands) Used for thin metals and aluminum.