Walking and Working Surfaces Preventing Slips, Trips, and Falls on the Job.
-
Upload
kerry-bryan -
Category
Documents
-
view
218 -
download
4
Transcript of Walking and Working Surfaces Preventing Slips, Trips, and Falls on the Job.
What’s the big dealabout slips and falls?
20% of all accidental deaths are related to slips and falls.
A California Workers’ Comp study revealed that work surfaces are the most common agent for job related injury.
Not only are slips and falls a work problem; they are the leading cause of accidental deaths in the home.
Basic Definitions
Slip - sliding of one or both feet ona surface
Trip - the motion of the foot is interrupted during a step.
Causes of Slips and Trips Sudden change of floor conditions Sudden change in floor elevation Obstructions in the walkway
Preventing Slips and Trips
Be prepared for weather related problems Wet surfaces Ice/snow Mud
Use slip resistant floor finishes and treatments
Keep aisles and walkways clear
Focus points for Slip/Trip/Fall Injuries
The normal line of sight is 15 degrees below the horizontal.
The center of gravity for the human body is normally about 3 inches above the mid-point of the person’s height.
Some common injury areas are: Stairs Scaffolds Ladders Roofs Tile and concrete
floors
Safety on Stairs
Stairs should be at the proper angle (30-35 degrees)
Handrails should be provided
Maintain at least 2 points of contact when walking on stairs
Do not store materials on stairs
Maintain good visibility
Safety on Ladders
Inspect ladders before use - Do Not Use Unsafe Equipment!
Assure proper toe space
Ladder angle should be 75 degrees maximum. Base of ladder should be 1 foot from wall for every 4 feet of vertical distance from the floor to the contact point.
Wall
Ladder
5’
ContactPoint
20’
Safety on Ladders
Ladders should be on stable footing and straight ladders should be anchored to prevent tipping.
Straight ladders should extend 3½ feet above the contact point.
Do not stand on the top step of a step ladder.
Do not lean over or reach/stretch while on a ladder.
Maintain 3 points of contact when ascending or descending.
Elevated Areasand Platforms
Scaffolds, mezzanines, and roof areas present hazards
Persons falling from the area and objects falling form the area
Striking the workers below.
Basic precautions can minimize the hazards.
Elevated Area Safety
Use covers on wall and floor opening to prevent falls.
Use standard 42” guardrails on scaffolds and platforms.
When necessary, use fall arrest systems (harnesses, safety belts, etc.) or safety nets to minimize impact injury from falling.
Special Concernsfor Scaffolds
Scaffolds must be properly constructed and braced.
They must be level and on solid footing.
Planking must be the proper grade of lumber and must be overlapped properly.
Consult 29CFR1910.28 for scaffold specifications and requirements.
Summary Points
Slips, Trips, and Falls account for a substantial portion of all accidents / injuries.
Good housekeeping and common sense safety practices can eliminate most of the injuries.
Communication and use of the proper equipment and procedures are the key to a successful Slip/Trip/Fall prevention program.