Uzi Restrictor Ring and Barrel Bushing
2
what about the fact that IMI mini carbine barrels dont have "B"? There is a gap (1) that when you push the barrel forward out of the restriction ring, you can wiggle it from side to side in that gap... there is currently no support here... the only support is the restriction ring area (2). Yes, I know that semi Mini carbine barrels do not have "B" which is a bad thing if you don't have the ring. Considering that in this country all transferrable FA Mini's are conversions, there is a good possibility that the ring is not present or that the ring can be removed with no legal issues. Also, since the semi and SMG trunions have the same INTERNAL dimensions they both can accept barrels that have "B". Note that Vector used full size UZI trunions in their Mini builds (ones made from Group receivers not the Vector/IMI Mini builds). The only time that I've seen issues with having the "B" are some Vector Semi Mini's built from re-welded Group receivers where the ring was not welded in with the proper alignment. Then it would get stuck. Take the same barrel and drop it in an IMI Mini carbine with the ring and it would go in fine. __________________
-
Upload
nester-tovar -
Category
Documents
-
view
86 -
download
2
description
u
Transcript of Uzi Restrictor Ring and Barrel Bushing
what about the fact that IMI mini carbine barrels dont have "B"?
There is a gap (1) that when you push the barrel forward out of the restriction ring, you can wiggle it from side to side in that gap... there is currently no support here... the only support is the restriction ring area (2).
Yes, I know that semi Mini carbine barrels do not have "B" which is a bad thing if you don't have the ring. Considering that in this country all transferrable FA Mini's are conversions, there is a good possibility that the ring is not present or that the ring can be removed with no legal issues.
Also, since the semi and SMG trunions have the same INTERNAL dimensions they both can accept barrels that have "B". Note that Vector used full size UZI trunions in their Mini builds (ones made from Group receivers not the Vector/IMI Mini builds).
The only time that I've seen issues with having the "B" are some Vector Semi Mini's built from re-welded Group receivers where the ring was not welded in with the proper alignment. Then it would get stuck. Take the same barrel and drop it in an IMI Mini carbine with the ring and it would go in fine.__________________
