Types of oscilloscopes (1)
-
Upload
ketki-jakatdar -
Category
Engineering
-
view
93 -
download
3
Transcript of Types of oscilloscopes (1)
WORKING :
It consists of two vertical deflection sections-
section A and section B.
It has two electron guns and one electronics switch.
Due to the switch only one beam can be
synchronized at a time.
Since, time base generator is same for both signals,
the signals have same frequency for locking in CRT
screen.
DIGITAL STORAGE OSCILLOSCOPE :
WORKING :
The analog input is converted to digital signal by 10 bit A/D
converter .
For one channel, memory storage capacity is 1024; for 2
channels it is 2048; and for all four channels it is 4096.
The analog input voltage is sampled, recorded in Record
Control.
Once the record is captured, we can make changes in it as
per we require because we can read the record without being
erased.
If memory is read out rapidly and
repetitively, then we can observe a continuous
waveform on the oscilloscope.
Pre-triggering recording allows the input
signal, preceding the triggered points, to be
recorded.
DSO records continuously until it gets a
trigger signal. Once the trigger signal is
received the recording stops.
Thus, the freezing data is stored before the
trigger signal is applied.
Adjustable trigger delay allows the
operator to control the stop point.
In DSO, the new data coming into
memory pushes out old data once
memory is full.