TSX C USB FIP USB Fipway offer, installation and configuration

Automation - End User Solutions

Quality & Customer

Division - Name - Date - Language 2

Automation Quality • Excellence • Support

End User Solutions

A TSXCUSBFIP adapter with its USB connection An installation guide

But to use the adapter the following items are required :

A TSXFPCG010 or TSXFPCG030 To be ordered separately.

A Fipway driver. Included in the CD driver (ref : TLXCDDRV20M V2.5 or higher). you can

download it from the Telemecanique web site (www.telemecanique.com)

TSX C USB FIP Communication AdapterOffer Description

Division - Name - Date - Language 3

Automation Quality • Excellence • Support

End User Solutions

But that will not be enough other requirement regarding the Compatibilities exist. Schneider Software

Unity V3.1 or Higher PL7 V4.5 SP4 or Higher

TSX C USB FIP Communication AdapterOffer Description bis

If you respect all these recommendations you will be able to : Fipway

Connect your PC to a remote PLC – Upload or Download application

Fipio / WorldFip Connect your PC to a remote PLC

– Upload or Download application

Division - Name - Date - Language 4

Automation Quality • Excellence • Support

End User Solutions

TSX C USB FIP Communication AdapterHow to install it

Install the Fipway driver. (The driver must be install before connecting the adapter)

Insert the USB cable from the adapter into the USB port on your PC The USB and ERR LEDs will light

Messages will pop up“Found New Hardware”

“Welcome to the Found New Hardware Wizard” window will open.Select “No, Not this time” and click Next

Select Install the software automatically and click Next

Click Finish

If this is the first time the adapter has been plugged into the system; the “Found New Hardward” message will pop up again and you will have to repeat all steps above.

The last message should be “New Hardware is ready to use”

.

Division - Name - Date - Language 5

Automation Quality • Excellence • Support

End User Solutions TSX C USB FIP Communication AdapterHow to configure it

Open Schneider Drivers Manager Select the USB-FIP Driver Configure the Fipway or Fipio Networks Parameters

(We can configure two adapters on one PC, UFP01 / UFP02)