Stone, bricks and mortar. Stone materials Igneous stone- created by volcanic processes or mantle...

download Stone, bricks and mortar. Stone materials Igneous stone- created by volcanic processes or mantle stone coming to the surface from erosition. Schists and.

If you can't read please download the document

Transcript of Stone, bricks and mortar. Stone materials Igneous stone- created by volcanic processes or mantle...

  • Slide 1
  • Stone, bricks and mortar
  • Slide 2
  • Stone materials Igneous stone- created by volcanic processes or mantle stone coming to the surface from erosition. Schists and other chrystaline rock formations Sedmentery stone created by 1. processes of erosion by water and wind reduce the stone and carry it to re-deposition locations in near shore environments. Sandstone, shale 2. The slow deposition of exoskeletons of deep water invertebrates. Limestone Metamorphic stone created by the geologic forces (pressure and heat) forming new stones from the sedentary stone beds. Marble (limestone), and slate (shale), quartzite (sandstone)
  • Slide 3
  • Obtaining Stone Field stone- Stone that is eroded and obtained without excavation Quarried stone- Stone that is obtained by excavating to the bedding of stone and then breaking portions of the stone from the quarry face. Stone was usually sold by the cord for fieldstone and by the perch for stone from the quarry
  • Slide 4
  • Working stone Scabbled stone Cut stone Dressed stone
  • Slide 5
  • Working stone to ashlar
  • Slide 6
  • Uncoursed stone (free stone)
  • Slide 7
  • Coursed stone, and ashlar quoinsHeader bondFlemish bond
  • Slide 8
  • Galleting (small stones in mortar)
  • Slide 9
  • Sawn stone
  • Slide 10
  • Bricks Bricks are manufactured building materials of clay, sand and water. The clay is dug and used as without changing its character. Kaolinite, Montmorillonite, illite and chorite are the most common clays for brick. The clay has numerous impurities which can change the color of the brick upon firing. Five percent ferric oxide produces the typical red color, when burned at moderate temperature (2,000 degrees F.). Mixed with sand and water, 3 parts sand to 7 parts clay. The bricks were formed by forcing clay into molds. Sanded or oiled molds created more consistent bricks and were called stock brick. Because the brick would shrink in drying and the heating process the brick molds were generally ten percent larger than the intended fired brick.
  • Slide 11
  • Slide 12
  • Slide 13
  • Slide 14
  • Rat-trap or rowlock bond rowlock and sailors
  • Slide 15
  • Slide 16
  • Slide 17
  • Jack arch
  • Slide 18
  • closers
  • Slide 19
  • Plaster lines on joists and ledger board
  • Slide 20
  • Slide 21