Steps to be performed to configure CTS+ on Solution manager (S00) for Portal (EP) transports
Steps To Configure One Sensor
description
Steps To Configure One Sensor. Gary Tipton. The Hardware:. Retro-reflective Photo Sensor. Actual Sensor. Device Box. To Configure the sensor:. Open up RS Logix software and select Device Net. Perform a scan of the system to see if the system recognizes any items in it’s network. - PowerPoint PPT Presentation
Transcript of Steps To Configure One Sensor
-
Steps To Configure One SensorGary Tipton
-
The Hardware:Retro-reflective Photo Sensor
-
Actual Sensor
-
Device Box
-
To Configure the sensor:Open up RS Logix software and select Device Net.Perform a scan of the system to see if the system recognizes any items in its network.After the device has been observed by the master, than a new address could be assigned to the device.
-
A better look:
-
Screen shot
-
A New Address:Right click on the device that you want to give a new address to.Select propertiesThe device information can be manipulated from there.Re-scan to ensure the new address takes
-
Properties
-
Name and Address
-
Re-Scan