Spring Kerchief
-
Upload
adele-saitta -
Category
Documents
-
view
8 -
download
0
Transcript of Spring Kerchief
© 2013 Sachiko Uemura
All rights reserved. For personal and non-commercial use only.
Abbreviations:
CO = cast on
BO = bind off
st(s) = stitch(es)
k = knit p = purl
yo = yarn over
pm = place marker
sm = slip marker
m1R = make 1 right
m1L = make 1 left
RS = right side
WS = wrong side
Spring Kerchief by knittimo
Materials:
Yarn A: 1 skein of Malabrigo Yarn Lace (470 yds / 50 g) - shown in Apple Green
Yarn B: 1 skein of Malabrigo Yarn Lace (470 yds / 50 g) - shown in Natural
US 3 (3.25 mm) and US 0 (2 mm) circular needles
2 stitch markers
Blocked Gauge: 24 sts and 42 rows = 4” in stockinette st
Measurements: 59” wide, 17” deep
Note:
This triangular kerchief is worked with yarn held double throughout.
Top: Yarn A x 2 (in stockinette)
Middle: Yarn A + B (in stockinette)
Bottom: Yarn B x 2 (in garter)
Directions:
Divide Yarn A into 1/3 and 2/3.
With 2 strands (1 from each) held together, CO 2 sts on larger needle.
Knit 7 rows. Pick up and knit 3 sts from garter ridges on left side of piece and 2 sts from CO sts. (7 sts)
Set-up (WS): k2, yo, p1, pm, p1, pm, p1, yo, k2 (9 sts)
Next (RS): k2, yo, k to marker, m1R, sm, k1, sm, m1L, k to last 2 sts, yo, k2 (4 sts increased)
Next (WS): k2, yo, p to last 2 sts, yo, k2 (2 sts increased)
Repeat last 2 rows.
When the smaller Yarn A is used up, join Yarn B. (Felted join works fine.)
Now with Yarn A and B held together, keep working the same until Yarn A is
almost used up, ending with a completed WS row.
Then, with remaining Yarn B held double, start working in garter st on smaller
needle. Keep increasing the same way.
(RS): same as above (4 sts increased)
(WS): k2, yo, k to last 2 sts, yo, k2 (2 sts increased)
(If you like to keep the center spine in stockinette st, purl the center st on WS.)
Work until just enough yarn for BO is left, ending with a completed WS row.
BO knitwise on RS with larger needle. Weave in ends. Wet block. Enjoy!