Spoon Electronic Scale Manual

Spoon Electronic Scale Manual 1, the main Function

Weighing. Count. Measurement 2key definitionsKEY ITUC

ON/OFFZERO/TAREMODEPCS

a) I Function: The system here in the off state, then the boot keys; b) I Function: ON state when the Click button to shut down function; c) T feature: When the weight range is greater than zero key here is peeled, except if the skincondition, weight (compared with zero) is greater than zero, then the continuous addition to leather, if less than zero, then the abolition of In addition to skin; when the weight of the range is less than zero key here is set to zero, forcing the current weight set to zero; d) U function: up to 4 optional units, the system turned on, click here to keys to switch the order of units. shutdown to save units. In the off state holding down this key and then turn key to enter calibration mode. e) C functions: counting function.3. Use function a) Press I key: turn after the show full-evident, pan stable display 0.0 (g), re-enter the state of mind. b) Press U key: Press U key and hold until the show CAL, put pan on the items take that, then a Mode button, flashing display "200g", began to calibration 0:00 to 200 grams of weight placed on pan If stable, then display "PASS" calibration over, return to weighing state; if unstable, then displays "FAIL", and automatically shutdown. Note: The 200g Calibration 300g. c) Press T key: the number of cases has stabilized, press T key to display the value is cleared. d) a short press C key: then enter the count of the state. e) When the sample without sampling: f) points in the boot state, click this button to enter the counting function, and values prevail over sub-samples are counted. g) To exit point of counting the state and then click the switch to weigh the state. h) 2, when the required sample sampling: i) in the boot state, placed in the pan on the sample. Long Press count button 2 seconds, the system shows the last sample of the sampling value, release; then by pressing the Mode button to adjust values to be sampled in the sampling time, every time I press the Mode button the number of samples plus 25, the biggest added to 100. Adjusted to the desired value and then click a button to confirm the sample COU, you can count the use. The state point in the count, click count COU key to exit function