Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė
description
Transcript of Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė
![Page 1: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/1.jpg)
1
Solid oxide membranes for hydrogen Solid oxide membranes for hydrogen
separation and isolationseparation and isolation
Aurelija MartiAurelija Martišiūtėšiūtė
![Page 2: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/2.jpg)
2
Membrane permeation mechanisms; Review of different types
conductivity;Experimental data;Results (XRD, SEM,Water
permeability test); Conclusion.
Outline of the presentation:
![Page 3: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/3.jpg)
3
There are two main membrane permeation mechanisms:
• Through the bulk of the material (dense membranes). A gas molecule is adsorbed on one side of the membrane, dissolves in the membrane material, diffuses through the membrane and desorbs on the other side of the membrane.
• Through pores (porous membranes). The separation factor for these mechanisms depends strongly on pore size distribution, temperature, pressure and interactions between gases being separated and the membrane surfaces.
![Page 4: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/4.jpg)
4
Chromium oxide Chromium oxide has characteristic of protonic – electronic conductivity, so it can be used as electrolyte where hydrogen can go toward cathode during electrolysis
![Page 5: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/5.jpg)
5
Schematic of the use of mixed oxygen ion – electronic conductor for oxygen separation with direct reforming of methane, followed by the use of mixed protonic – electronic conductor for hydrogen extraction. The products are thus pure hydrogen and synthesis gas with reduced hydrogen content
Oxygen ion – electronic & Protonic - electronic conductivity
![Page 6: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/6.jpg)
6
Hydrogen separation from mix gases during catalysis
CH4 → CH●3 + H●
H● → H+ + e -
2H+ + 2e- → H2
![Page 7: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/7.jpg)
7
There are different types of conductivity:
Polymer based proton exchange materials (PEMs);Mixed oxygen ion – electronic conductors;High temperature, acceptor – doped system with mixed protonic – p – type or n – type electronic conduction;Reduced materials with mixed protonic and n – type electronic disorder;Materials with water or crystallographic protons;Hydrogen insertion compound.
![Page 8: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/8.jpg)
8
Pulse DC:Experiment :
t
U
![Page 9: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/9.jpg)
9
XRD RESULTS
PNSi5: p=2Pa, I=1A, U=345V, UBias=100V, IBias=0.01A, thickness=2.47µm, t=3h
PNSi6: p=5.3Pa, I=1A, U=360V, UBias=100V, IBias=0.01A, thickness=1.47µm, t=3h
PNSi8: p=2Pa, I=1A, U=345V, thickness=2.38µm, t=3h
10 20 30 40 50 60 70
0
500
1000
1500
2000
2500
3000
3500
4000
4500
PNSi6PNSi8
r-Cr2O3(110) r-Cr2O
3(116)
r-Cr2O3(300)
PNSi5
Si substrate
Inte
nsity
, arb
.u.
difraction angle,2 theta
![Page 10: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/10.jpg)
10
Cross – section of chromium oxide film
PNSi5: p=2Pa, I=1A, U=345V, UBias=100V, IBias=0.01A, thickness=2.47µm, t=3h
Cross – section image (SEM)
![Page 11: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/11.jpg)
11
Si substrate and chromium oxide film on it(PNSi5)
SEM RESULTS
PNSi5: p=2Pa, I=1A, U=345V, UBias=100V, IBias=0.01A, thickness=2.47µm, t=3h
![Page 12: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/12.jpg)
12
Cross – section of chromium oxide film
Cross – section image (SEM)
PNSi6: p=5.3Pa, I=1A, U=360V, UBias=100V, IBias=0.01A, thickness=1.47µm, t=3h
![Page 13: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/13.jpg)
13
Si substrate and chromium oxide film on it(PNSi6)
SEM RESULTS
PNSi6: p=5.3Pa, I=1A, U=360V, UBias=100V, IBias=0.01A, thickness=1.47µm, t=3h
![Page 14: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/14.jpg)
14
Cross – section image (SEM)
Cross – section of chromium oxide film
PNSi8: p=2Pa, I=1A, U=345V,
thickness=2.38µm, t=3h
![Page 15: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/15.jpg)
15
Si substrate and chromium oxide film on it(PNSi8)
SEM RESULTS
PNSi8: p=2Pa, I=1A, U=345V,
thickness=2.38µm, t=3h
![Page 16: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/16.jpg)
16
10 20 30 40 50 60 700
200
400
600
800
1000
1200
1400
1600
1800
2000
MOTTCr23
r-Cr2O
3(300)
r-Cr2O
3(113)
r-Cr2O
3(110)
MOTTCr22r-Cr
2O
3(300)
r-Cr2O
3(110)
MOTTCr21
MOTT substrate
MOTTCr20
r-Cr2O
3(110)
Substrate
Inte
nsity
, arb
.u.
difraction angle, 2 theta
XRD RESULTS
MOTTCr20: p=2Pa, I=1A, U=345V, UBias=100V, IBias=0.01A, thickness=2.31µm, t=3h
MOTTCr21: p=5.3Pa, I=1A, U=360V, UBias=100V, IBias=0.01A, thickness=2.2µm, t=3h
MOTTCr22: p=5.3Pa, I=1A, U=365V, thickness = ?µm, t=3h
MOTTCr23: p=2Pa, I=1A, U=345V, thickness=2.55µm, t=3h
![Page 17: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/17.jpg)
17
SEM RESULTS
MOTTCr20: p=2Pa, I=1A, U=345V, UBias=100V, IBias=0.01A, thickness=2.31µm, t=3h
MOTT substrate and chromium oxide film on it(MOTTCr20)
![Page 18: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/18.jpg)
18
MOTT substrate and chromium oxide film on it(MOTTCr21)
SEM RESULTS
MOTTCr21: p=5.3Pa, I=1A, U=360V, UBias=100V, IBias=0.01A, thicknes=2.2µm, t=3h
![Page 19: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/19.jpg)
19
MOTT substrate and chromium oxide film on it(MOTTCr22)
SEM RESULTS
MOTTCr22: p=5.3Pa, I=1A, U=365V, thickness =?µm, t=3h
![Page 20: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/20.jpg)
20
MOTT substrate and chromium oxide film on it(MOTTCr23)
SEM RESULTS
MOTTCr23: p=2Pa, I=1A, U=345V, thicknes=2.55µm, t=3h
![Page 21: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/21.jpg)
21
Water permeability test
Sample R1, Ω R2, Ω R3, Ω
MOTTCr20 0.05 15 ×106 4 ×106
MOTTCr21 0.05 106 2.8 ×106
MOTTCr22 0.05 10 ×106 3.5 ×106
MOTTCr23 40 106 13 ×104
Sample R1, Ω R2, Ω R3, Ω
PNSi5 8 ×106 4 11 ×106
PNSi6 8 ×106 6.5 13 ×106
PNSi8 8 ×106 5 5 ×106
![Page 22: Solid oxide membranes for hydrogen separation and isolation Aurelija Marti šiūtė](https://reader035.fdocuments.us/reader035/viewer/2022070502/56813e9e550346895da8ebcb/html5/thumbnails/22.jpg)
22
CONCLUSIONS:
Chromium oxide has mixed protonic – electronic conductivity, so it can be used as membrane for hydrogen separation from other gases.Thin chromium oxide films were deposited on plains silicon substrates and porous substrates. On silicon substrates we detected amorphous phase practically in all films;XRD analysis shows that when chromium oxide film is deposited on porous substrate, dominates rombohedric phase of Cr2O3.SEM analysis shows that chromium oxide films are porous and characterize island grow.It was done water permeability test. Results are negative, water leak through chromium oxide membranes.