Micro-slotting technique for measurement of local residual ...
SLOTTING GUIDE - Raceseng
Transcript of SLOTTING GUIDE - Raceseng
![Page 1: SLOTTING GUIDE - Raceseng](https://reader033.fdocuments.us/reader033/viewer/2022051603/628065311524367c347ab1b4/html5/thumbnails/1.jpg)
TOW HOOK COVERSLOTTING GUIDE
![Page 2: SLOTTING GUIDE - Raceseng](https://reader033.fdocuments.us/reader033/viewer/2022051603/628065311524367c347ab1b4/html5/thumbnails/2.jpg)
TOOL LIST
• Electric Drill• 5/16” Drill Bit• Small Round and Flat Files• Dremel Tool• Small Dremel Cutting Wheel• Center Punch• Masking Tape• Sharpie Marker
SLOTTING GUIDE
1 Print out the Tow Hook Cover Slot Guide** Make sure your printer is set to a 1:1 scale. The slot on the printout should measure 5/16” x 2 1/4”. **
2 Cutout around the slot guide printout and place it on your tow hook cover. Make sure the black slot is level and placed in a position where it can be cut through the tow hook cover.
![Page 3: SLOTTING GUIDE - Raceseng](https://reader033.fdocuments.us/reader033/viewer/2022051603/628065311524367c347ab1b4/html5/thumbnails/3.jpg)
4 Use a center punch and punch the white dots on the outer ends of the slots.
3 Place masking tape over the slot printout. The masking tape holds the printout in place and also protects the paint from chipping.
![Page 4: SLOTTING GUIDE - Raceseng](https://reader033.fdocuments.us/reader033/viewer/2022051603/628065311524367c347ab1b4/html5/thumbnails/4.jpg)
5 Use an electric drill and 5/16” drill bit to drill holes on the punched marks.
6 Use a sharpie marker to outline the edges of the slot.
![Page 5: SLOTTING GUIDE - Raceseng](https://reader033.fdocuments.us/reader033/viewer/2022051603/628065311524367c347ab1b4/html5/thumbnails/5.jpg)
7 Use the Dremel tool to cut along the sharpie marks.
8 Fully cut the inner opening out.
![Page 6: SLOTTING GUIDE - Raceseng](https://reader033.fdocuments.us/reader033/viewer/2022051603/628065311524367c347ab1b4/html5/thumbnails/6.jpg)
9 Use small round and flat files to finish the edge of the cutout.
10 Remove the masking tape and install your cover.