SLIDING MACRAME BRACELET - Beadalon - Tying Station.pdf · 2019-03-28 · 3. Tie 4 square macrame...
Transcript of SLIDING MACRAME BRACELET - Beadalon - Tying Station.pdf · 2019-03-28 · 3. Tie 4 square macrame...
PAGE 1
Materials bull 129U-010 - Polyester Braided Cordbull 211F-100 WildFire Cord Cutterbull 216S-210 - Tying Stationbull 9 large holed beads
1 Double a 30rdquo piece of Poly Cord around the top peg of the Tying Station Thread 5 large holed beads onto both of the cords and secure them in the bottom plate
3 Tie 4 square macrame knots (right over left - left over right) then push a bead up into place against the last knot Continue to tie 4 knots between each bead until all beads are captured End with 4 macrame knots
2 Double the remaining Poly Cord and knot it in the center to the top of the doubled cord at the 35rdquo mark
4 Trim and seal the ends of the knotted Cord with the WildFire Cord Cutter Size the bracelet to fit your wrist when it slides open On each loose cord add a large holed bead and capture it with a knot
1
4
2
5
reg
SLIDING MACRAME BRACELETBy Meredith Roddy
5 Line the two sides up facing opposite ways and tie them together using one of the scraps of Cord Tie about 10 macrame knots to secure into place
6 Trim and seal the ends with the WildFire Cord Cutter
3
6