Sandvik DL331-5 Underground Drill Rig · 2020. 9. 16. · Sandvik DL331-5 is a highly versatile...
Transcript of Sandvik DL331-5 Underground Drill Rig · 2020. 9. 16. · Sandvik DL331-5 is a highly versatile...
Technical Specification7-6360-C2012-05-21
Sandvik DL331-5Underground Drill Rig
1/4
© 2
011
San
dvik
Min
ing
and
Co
nst
ruct
ion
Sandvik DL331-5 is a highly versatile single boom electro-hydraulic long-hole drilling jumbo for smalland medium scale production drilling in under-ground mines. The rig is capable of drilling severallines of parallel holes, up and down, up to 23 mdepth, from a single machine position over the widthof 5.5 m.
The 360° rotation in full parallel coverage area andwide tilt angle ranges forward and backward makethe robust universal telescopic boom suitable to vari-ous drilling applications. The long reach of theboom also allows safe access to unsafe or narrowplaces such as vein drilling or raise drilling.The jumbo layout is designed for good visibility and balance, this and the powerful four-wheel-drivearticulated carrier ensure fast and safe manoeuveringin narrow drifts.
The high performance drilling system allows highdrilling performance with good drill rod economyand high machine reliability.
The operator environment and added automaticfunctions allow the operator to concentrate on safe,fast and accurate drilling.The new carrier is designed for better access to thedaily service points.
Carrier NC5
Boom SB60P
Feed LHF 2000-5
Rod handler (optional) ERHC12
Rock Drill HLX5, 20 kW
Hole diameter 51 - 64 mm
Hole length Up to 23m
Control system THC560 LH, Hydraulic
Cornering 4010 mm
Total weight 15 200 Kg(depending on options)
Technical Specification
Sandvik DL331-57-6360-C
2012-05-21
2/4
Coverage area
68003265 3535
2200 2400
DL33
1
SANDVIK
7665R3225
4565
3100
55°
25°R2725
2110
309531°29°
DL33
1
SANDVIK
FEED ROD Mini A Maxi ALHF2004 1220 3000 4000LHF2005 1525 3300 4300LHF2006 1830 3600 4600
A
Up to7000*
160
* Maxi section with standard rear anchor.The boom allow to reach width up to 7000 mm and height (B) up to 6740 mm.Please note that an additional anchoring system is needed.
All dimensions in mm
5480Parallel Holes
Rock drill HLX5Percussion power 20 kWPercussion pressure Max. 220 barPercussion rate 67 HzRotation speed Max. 250 rpm (with OMS80)Rotation torque 400 Nm (with OMS80)Hole size (drifting) 51 - 64 mmHole size (cut hole) 76 - 127 mm
Recommended rodT38 - R32T38- alpha 330T38-R35
Shank adapter T38 (male)Weight 210 kgLength 955 mmProfile height 87 mmShank lubrication device Air /oil mist SLUShank lubrication compressor CT10, 1m³/min (7 bar)Air consumption 250 - 350 l/minOil consumption 180 - 250 g/h#Power extractor For HLX5
Hydraulic rock drill Technical Specification 2_1862
Boom type SB60PParallelism Automatic hydraulicBoom extension 1200 mmRear stinger 1200mmBoom weight, net 2 400 kgRoll-over angle 360°
Boom Technical Specification 4_3120
Feed LHF2006Feed force 20 kNFeed extension 1200 mnExtension rod Round 32/39/46#Front stinger 600mm
Optional Optional Standard
LHF 2004
LHF 2005
LHF2006
Total length (mm)
2850 3155 3460
Extension rod length (mm)
1225 1525 1830
Min. operating dimension (mm)
3000 3300 3600
Net weight (kg) 710 725 740
Feed Technical Specification 3_3055 S
Capacity MF rods R32MF rods T38MF rods T45
12+111+110+1
ERHC 12 Rod carrousel Technical Specification 3_601
#AngleTIS DDS (drilling direction, depth andspeed) with data logging
Instrumentation options Technical Specification 5_9250
* Alternative options features/components# Additional options features/components
Technical Specification
Sandvik DL331-57-6360-C
2012-05-21
3/4
Machine dimensions
3070
1750 on frame
Max. 3305DL
331
SANDVIK
1500
6745
2810
9760
1500
1200Zoom
*The 2 min.FOPS/ROPS heightare marked with red paint on the canopy tube
FOPS/ROPS certified position* HSeated operation From 2430 to 3100
Standing operation From 2930 to 3100
160
1875 on wheels
H
All dimensions in mm
Powerpack HPP 555 (55kW)Percussion pump 100cc (variable)Rotation pump 45 cc (gear)Oil tank volume 180 liters
Filtration size20 micron (pressure)10 micron (return)
Tank filling Electric pump
Oil coolerCooling capacity 30 kWOW30 water cooler
#Biodegradable oils Shell Naturelle HFE
Hydraulic system
Type THC 560, LH hydraulic
Full and collaring powerReduced power for collaring,full power for drilling andAdjustable
Rotation speed Adjustable at control panelDrilling feed thrust pressure Adjustable at control panelAntijamming system AutomaticWater flushing Automatic
Drilling air/water flushing Manual selection at controlpanel
Stop and return AutomaticBack pressure Adjustable at control panelFeed controlled percussion AutomaticBoom controls Fully proportionalWarning display
Control system Technical Specification 5_1010
#Pressure cleaning system with reel 5-15 bar#High pressure cleaning system with reel Max. 180 bar
Cleaning system
#Greasing unit with reel,pump and nozzle Manual
#Automatic greasing systemCarrier, boom and cassette
Greasing systems and options
Total input power 70 kWMain switch MSE 5Standard voltages 380-690 VAC*Optional voltage 1000 VAC, 50 HzVoltage fluctuation ± 10%Automatic cable reel TCR I
Cable reel control (in & out)Operator station and rear of unit
Batteries 2x12V, 95Ah, 850A#Star delta starter 380VAC - 575VAC#Electric cable rubber or PUR Depending on voltage#Ground fault and overcurrent protection
VYK
#Electric power interlockPowerpack starts only when jacks are on ground
#Optional outlet230V outlet Max.4500VA3-phase outlet, network voltage
Electric system and options
Flushing WaterWater pump WBP I (4 kW)Water pump capacity 33 l/min (15bar / 4bar inlet)Water pump inlet pressure 2-7 bar (while drilling)Flushing water pressure Max. 20 bar*Optional Compressor CT16 (11kW, 1.6m3/min)External air connection IP5 air cleaner
#Air mist flushingFor external supplyof air and water
#Water flushing with air cleaning of hole
External water and air supplyExternal water and internal airwith CT16 compressor
#Water hose reel with water hose
THR32mm (1¼”), 80 meters
#Water hose with hooks 32mm (1¼”), 80 meters
Flushing system and options
#Hand held fire extinguisher 1 pcs#Manual fire suppression system 6 nozzles#Automatic fire suppression system 6 nozzles
Fire suppression system and options Tech. Spec. 5-9800
* Alternative options features/components# Additional options features/components
Technical Specification
Sandvik DL331-57-6360-C
2012-05-21
4/4Sandvik Mining and Construction Lyon S.A.S BP46 - FR-69881Meyzieu Cedex, France - Tel. +33 4 7245 2200 - Fax +33 4 7831 7980www.sandvik.com
Sandvik Mining and Construction reserves the right to change this specification without further notice.
© 2
011
San
dvik
Min
ing
and
Co
nst
ruct
ion
Tramming dimensionsOverall Length
LHF 2004 11120LHF 2005 / 2006 11415
Overall length
3100
2100750
750
40106600
3180
40°
DL33
1
SANDVIK
19501830
15°16°
All dimensions in mm
Tramming speedHorizontal: 12 km/h14% = 1:7 = 8° 5,0 km/h
Gradeability / Inclination Max. 15° / 5°
Tramming
Safety canopyFOPS/ROPS (ISO3449)ROPS < 15700 kg
Operation Standing drilling, seated tramming
SeatErgonomic, adjustable, including seat belt
*SeatSeat with arm restsT back seat
Noise level(EN791, free field condition)
Operator station: < 95 dB(A)
#Front screen protection bar
Operator station
Front lights(combined working and driving)
2 x 35 W HID +2 x 70 W (24V)
Rear working lights 2 x 70 W (24V)Rear driving lights 2 x 70 W (24V)Positioning lights 2xlaser typeManual search light 1 x 70W (24V)#Extra working lights 2 x 35 W HID (24V)#Amber strobe light Flashing (24V)
Lights and options
#Regional LAM, USC, AUS, EUR
#Harsh water optionsL1: Oil cooler + boom cylindersL2: L1 + steering and jacks cylinders
Packages
Carrier NC5Carrier type Wheel mounted, frame steeringFrame steering ± 40°Rear oscillation ± 10°Ground clearance 320 mmDiesel engine Deutz BF4M2011, 62kW, Tier 2*Deutz TCD 2012 74kW, Tier 3 Diesel engine control Electronic, EMRExhaust catalyzer StandardTransmission Hydrostatic, automotiveAxles Spicer 112 / Spicer 123Tyres 12.00-20*Optional tyres Foam filled tyres
Service BrakesHydrostatic drive system andSAHR type, fail safe wet discbrakes.
Parking and emergency BrakesSAHR type, fail safe wet discbrakes
Fuel tank 80 litersTramming hydraulic oil tank 55 liters
Hydraulic jacksOutriggers (front) *Telescopic jacks (front)Vertical (rear)
Brake release Manual hand pump#Fast filling systems Complete #Wheel chocks and holder 2 pieces#Battery jump start#Automatic reversal of the fanrotation for cleaning
Carrier
Spare rock drillSpare wheel assembly Standard or foam filledSpecial tools for rock drillDocumentation Extra manuals
Extra items
* Alternative options features/components# Additional options features/components