QUESTION

JUAN CARLOS MUÑOZ GÓMEZ

ELECTROMECHANIC

1. ALWAYS EXAMINE THE TOOL FOR DAMAGES BEFORE USE. A. TRUE

2. IT IS OK TO WEAR LOOSE CLOTHING, DANGLING OBJECTS AND JEWELLERY USING HAND TOOL.

B. FALSE

3. KEEP CORDS AND HOSES AWAY FROM HEAT, OIL AND SHARP EDGES. A. TRUE

4. USE ONLY TOOLS AND EQUIPMENT IN GOOD CONDITION. A. TRUE

5. IT IS OK TO MAKE ADJUSTMENTS OR CLEAR A JAM WHILE THE POWER TOOL IS RUNNING. B. FALSE

6. IF ANY TOOL BREAKS OR MALFUNCTIONS, REPORT IT TO YOUR SUPERVISOR IMMEDIATELY. A. TRUE

7. BEFORE CONNECTING TO A POWER SOURCE, MAKE SURE THE POWER IS ON. B. FALSE

8. SAFETY GLASSES SHALL ALWAYS BE WORN WHENEVER YOU ARE USING POWER HAND TOOL. A. TRUE

9. THERE ARE SEVERAL TYPES OF POWER TOOLS, INCLUDING ELECTRIC, PNEUMATIC, HYDRAULIC. A. TRUE

10. NEVER USE ELECTRIC TOOLS IN WET CONDITIONS. A. TRUE

11. WHEN NOT IN USE, POWER TOOLS SHOULD BE DISCONNECTED. A. TRUE B. FALSE

12. KEEP SAFE DISTANCE BETWEEN YOUR HANDS AND ALL MOVING PARTS OF THE POWER TOOL. A. TRUE

13. DON’T LEAVE A POWER TOOL UNATTENDED WHILE IT IS RUNNING. A. TRUE

14. IT IS OK TO STARTLE SOMEONE WHO IS USING A POWER TOOL. B. FALSE

15. USE SAFETY GUARDS EXACTLY AS THEY ARE SUPPOSED TO BE USED. A. TRUE

16. WHEN TIGHTENING A NUT WITH AN ADJUSTABLE WRENCH, ALWAYS PULL THE WRENCH TOWARD YOU; NEVER PUSH THE WRENCH AWAY FROM YOU. A. TRUE

17. PLASTIC COVERED HANDLES ON WIRE-CUTTING PLIERS MAY BE USED TO CUT LOW-VOLTAGE LIVE ELECTRICAL WIRE. A. TRUE

18. SCREWDRIVERS MAY BE USED FOR PURPOSES OTHER THAN DRIVING OR REMOVING SCREWS, FOR EXAMPLE AS A CHISEL. B. FALSE

19. WHEN SELECTING A STANDARD SCREWDRIVER BE CERTAIN THAT THE TIP IS ALMOST AS THICK AND AS WIDE AS THE SLOT OF THE HEAD OF A SCREW. B. FALSE

20. WHEN USING A HACKSAW, SAFETY GLASSES MUST BE WORN. A. TRUE

21. WHEN YOU ARE FINISHED USING A HACKSAW, TENSION SHOULD BE EASED. A. TRUE