7/28/2019 phase 3 system 20.pdf

1/2

Bulletin Number 4396

Date: 10/08/03

To: All Konica Minolta Digital Copier Dealers

From: Service Support

Subject: PHASE 2 SYSTEM SOFTWARE TO PROVIDE LDAP SUPPORTFOR THE Pi4700e.

Pi4700e: 002

LDAP (Lightweight Directory Access Protocol) support is now available for the Pi4700e print controller. LDAPis an Internet protocol that e-mail programs use to look up contact information from a server. LDAP eliminatesthe need to input the entire e-mail address in order to scan to e-mail. With LDAP, users input a few letters ofthe name or address of the desired e-mail recipient and press Start Search. The controller then performs areal time search of the LDAP enabled e-mail server for possible matches then allowing the user to select thedesired address from the list of possible matches.

In addition to LDAP support the Pi4700e Phase 2 System Software adds the ability to scan to the HDD of thecontroller, with scan retrieval via the new Pi4700e Network Twain Driver. The optional Hard-Disk Drive ItemNumber 4623-441 must be added to the controller for support of this function.

The following updates will be necessary to allow the Pi4700e and the Di470 to be compatible and support thefunctionality added by the Phase 2 System Software.

1) The firmware of the copier must be updated to the latest version available on Technical Service Bulletinnumber 4268a.

2) The Pi4700e System Software must be updated to version 3.0. The update can be carried out usingPageScope Light, sending the file to the Pi4700e using the maintenance tab. This method of updatingthe print controller firmware is the same as that for the Pi5501 and Pi3502. Complete step-by-stepinstructions are available on Technical Service Bulletin 3965. The Pi4700e firmware file is attached tothis bulletin on the PartnerLink Web site for download. The attached file name is md2sownv300.

3) The NIC firmware must also be updated to version 6.32A. The firmware for the NIC is updated usingthe two utilities attached to this bulletin. The IPX Flash Up is used for updating the NIC connected on

Novell networks and the TCPIP FTPDL is used when connected to TCP/IP networks. Contained in theNIC utility folder are the steps to use the download utility to carry out the firmware update. The NICfirmware file is attached to this bulletin on the PartnerLink Web site for download. The attached filename is dls632a.udp.

SERVICE & SUPPORT DIVISION

Software

Available as a part

PartnerLinkXDownloadable

7/28/2019 phase 3 system 20.pdf

2/2

Page 2 of2 Bulletin Number 4396

NOTE:

When version 3.0 has been installed on the Pi4700e the Controller Type and Peripheral Mode

on the Di470 must be changed. The Controller Type should be set to 6. The Peripheral Mode

should be set to Mode 2 with the HDD installed and Mode 3 when the HDD has not been installed

in the controller.

For the configuration and setup of the Pi4700e please reference the updated User and Service

Documentation available on PartnerLink.