NEO Hand Held Computer Quick Start Guide - English
2
UVW XYZ A B C D E F K P G L Q R H M I N O T S J Contents of the box: Features: Front LED indicator NEO Hand-Held Computer Lanyard This Guide Battery [ENTER]/Power key EULA documents Display Keyboard Docking port Features: Back Features: Alphanumeric Keyboard Features: Numeric Keyboard Features: Battery Compartment Getting Started Unlatch and open the battery compartment. 1 Insert the battery. 2 Close and latch the battery compartment. 3 Over ISO 9001 Certified� Quality Management System [FN/BLUE] key [FN/BLUE] key [FN/ORANGE] key [FN/ORANGE] key Scan key MicroSD Card holder Serial number label Battery-detection magnet (inside battery cover) Battery cover Receiver Scanner window Hand-Held Computer Stylus Beeper Scan key $ [ENTER]/ Power key [ENTER]/ Power key Battery contacts Wrist strap Accessory attachment point Expansion-port cover Battery compartment Microphone Beeper Battery cover latch Microphone Microphone Accessory attachment point Accessory attachment point September 30, 2008 PN: 8100158.A
-
Upload
spirit-data-capture-limited -
Category
Documents
-
view
228 -
download
0
description
Â
Transcript of NEO Hand Held Computer Quick Start Guide - English
UVW XYZ
A B C D E
F
K
P
G
L
Q R
H
M
I
N O
TS
J
Contents of the box:
Features: Front
LED indicator
NEO Hand-Held Computer
Lanyard
This Guide
Battery
[ENTER]/Power key
EULA documents
Display
Keyboard
Docking port
Features: Back Features: Alphanumeric Keyboard
Features: Numeric KeyboardFeatures: Battery Compartment
Getting StartedUnlatch and open the battery compartment.1
Insert the battery.2
Close and latch the battery compartment.3
Over
ISO 9001 Certified�Quality Management System
[FN/BLUE] key
[FN/BLUE] key
[FN/ORANGE] key
[FN/ORANGE] key
Scan key
MicroSD Card holder
Serial number label
Battery-detection magnet (inside battery cover)
Battery coverReceiver
Scanner window
Hand-Held Computer
Stylus
Beeper Scan key
$
[ENTER]/ Power key
[ENTER]/ Power key
Battery contacts
Wrist strap
Accessory attachment point
Expansion-port cover
Battery compartment
MicrophoneBeeper
Battery cover latch Microphone
Microphone
Accessory attachment point
Accessory attachment point
September 30, 2008 PN: 8100158.A
ISO 9001 Certified Quality Management System
To suspend the NEO, do either of the following:Press and release the [FN/BLUE] key, then press the [ENTER] key.•Select • Shutdown, then select Suspend from the Start menu.
Resetting the NEOImportant: Resetting the unit may result in data loss.
To warm-reset the NEO:Press the [BLUE] and [ENTER] keys simultaneously •for six seconds, orSelect • Shutdown, then select Warm Reset from the Start menu.
Turn the unit on. Press the [ENTER]/Power key for two seconds.
5
Charge the battery. Insert the NEO into a Docking Station or connect a charger.
4
AllowtheNEOtochargeforthreehoursbeforefirstuse.
Note: Use only the universal AC power supply approved by Psion Teklogix for use with the Docking Station.
Note: Full battery performance is only reached after thefirstfewcharge/dischargecycles.3h
5 - 40 °C 41 - 104 °F
Hand-Held Computer
Quick Start Guide
Psion Teklogix and NEO are trademarks of Psion Teklogix Inc. Other product names mentioned in this document are trademarks or registered trademarks of other hardware, software, or service providers and are used herein for identificationpurposesonly.
™
[ENTER]/Power key
[ENTER]/Power key
Note: During charge, the LED indicator on the NEO is YELLOW until charging reaches 75%. Between75%and95%theindicatorflashesGREEN slowly, and, above 95%, the indicator is GREEN continuously. The LED indicator on the Docking Station behaves the same when a spare battery is being charged.
*8100158*8100158
Rev. A
September 30, 2008 PN: 8100158.A
