NASSP Masters Project 2017 University of the Western Cape ...
1
NASSP Masters Project 2017 University of the Western Cape Dispersion measure variations in pulsar observations with LOFAR Supervisor: Maciej Serylak 1,2 email: [email protected] Co-supervisor: Aris Karastergiou 3,4,2 email: [email protected] 1 SKA South Africa 2 Department of Physics & Astronomy, University of the Western Cape 3 Oxford Astrophysics, University of Oxford 4 Department of Physics and Electronics, Rhodes University Background The interstellar medium (ISM) is the gaseous matter between the stars of a galaxy. As radio emission from pulsars propagates through the ionized interstellar medium (ISM) it interacts with free electrons leading to observable prop- agation effects. One of these effects is dispersion. This effect is immediately obvious in frequency-resolved pulses from radio pulsars: the pulses observed at lower radio frequencies arrive later at the telescope than their higher fre- quency counterparts (see Fig. 1). This delay is inversely proportional to the square of the observing frequency and the constant of proportionality is called the Dispersion Measure (DM). By precise analysis of the DM and its tem- poral variations one can get information about the ISM structure (see Fig. 1). The dispersive delay is much more pronounced at the low observing frequencies of LOFAR - a radio telescope designed to operate at frequencies around 100 MHz. Low frequency observations allow to probe time-dependent changes in the ISM at very high precision and to improve measurements of contributions from higher-order dispersive terms, if these exist, thereby strongly constrain the general ISM properties. Figure 1: Left: Pulse dispersion. Dispersive delay seen in a pulsar observation done with LOFAR. Right: Dispersion measure variations for various radio telescopes (including LOFAR) with DM variation model plotted with the data. Project Description The project involves work with a large sample of pulsar observations taken with LOFAR radio telescope. The ob- servations are made with weekly cadence starting from 2013 and are still ongoing. The data reduction and analysis will be made using readily available pulsar reduction tools (PSRCHIVE, TEMPO2). Good knowledge of Linux operating system is an advantage. The project will involve programming in PYTHON and possibly in C. The work will be done in the SKA Office in Pinelands and the necessary facilities will be provided. Further Reading Lorimer, D.R & Kramer, M. Handbook of Pulsar Astronomy, 2005, Cambridge University Press
Transcript of NASSP Masters Project 2017 University of the Western Cape ...
NASSP Masters Project 2017 University of the Western Cape
Dispersion measure variations in pulsarobservations with LOFAR
Supervisor: Maciej Serylak1,2 email: [email protected]: Aris Karastergiou3,4,2 email: [email protected] South Africa2Department of Physics & Astronomy, University of the Western Cape3Oxford Astrophysics, University of Oxford4Department of Physics and Electronics, Rhodes University
Background
The interstellar medium (ISM) is the gaseous matter between the stars of a galaxy. As radio emission from pulsarspropagates through the ionized interstellar medium (ISM) it interacts with free electrons leading to observable prop-agation effects. One of these effects is dispersion. This effect is immediately obvious in frequency-resolved pulsesfrom radio pulsars: the pulses observed at lower radio frequencies arrive later at the telescope than their higher fre-quency counterparts (see Fig. 1). This delay is inversely proportional to the square of the observing frequency andthe constant of proportionality is called the Dispersion Measure (DM). By precise analysis of the DM and its tem-poral variations one can get information about the ISM structure (see Fig. 1). The dispersive delay is much morepronounced at the low observing frequencies of LOFAR - a radio telescope designed to operate at frequencies around100 MHz. Low frequency observations allow to probe time-dependent changes in the ISM at very high precisionand to improve measurements of contributions from higher-order dispersive terms, if these exist, thereby stronglyconstrain the general ISM properties.
Figure 1: Left: Pulse dispersion. Dispersive delay seen in a pulsar observation done with LOFAR. Right: Dispersionmeasure variations for various radio telescopes (including LOFAR) with DM variation model plotted with the data.
Project Description
The project involves work with a large sample of pulsar observations taken with LOFAR radio telescope. The ob-servations are made with weekly cadence starting from 2013 and are still ongoing. The data reduction and analysiswill be made using readily available pulsar reduction tools (PSRCHIVE, TEMPO2). Good knowledge of Linuxoperating system is an advantage. The project will involve programming in PYTHON and possibly in C. The workwill be done in the SKA Office in Pinelands and the necessary facilities will be provided.
Further Reading
Lorimer, D.R & Kramer, M. Handbook of Pulsar Astronomy, 2005, Cambridge University Press
