Materi Solid Work

MATERI I INTRODUCTION (SOLIDWORKS)

1. PENGAKSESAN SOLIDWORKS

Part modeling

Assembly modeling

2D drawing

2. PEMODELAN 3D SOLIDWORKS

3. SOLIDWORKS LAYOUT

Pull down menu View orientation, 2D and 3D

Principal planes

Sketch toolbar

Standard menu

Right click on any principal plane icon

MATERI II PART MODELLING

1. Penggunakan features dasar pemodelan 3 dimensi (extruded boss ,

extruded cut , circular pattern , dan hole ) CASE (HOUSING VALVE)

Langkah Pemodelan :

• Sket (seperti gb.dibawah) dan extruded boss 56 mm


• Circular pattern (3 instances , 1200)

• Sket (seperti gb.dibawah) dan extruded boss (offset 40.5 , up To surface)

• Hole > type counterbored (dia = 14, depth = 71, C-Bore dia = 25, C-Bore

depth = 5)

• Sket (seperti gb.dibawah) dan extruded cut 8 mm

• Circular pattern (3 instances , 1200)

2. Aplikasi pemodelan 3 dimensi untuk komponen assembling CASE ( WHEEL ASSEMBLY)

a) TOP PLATE Langkah Pemodelan :


• Sket (seperti gb.dibawah) dan extruded cut

• Hole > simple > diameter = 11 mm, depth = 16 mm • Linear pattern > arah x (2 inst spacing =112), arah y (2 ins, spacing = 58)

b) AXLE SUPPORT Langkah Pemodelan :



• Sket (seperti gb.dibawah) dan extruded boss 2 mm • Hole > simple > diameter = 18 mm, depth = 12

• Sket (seperti gb.dibawah) dan rib = 9 mm (both side)

• Fillet radius = 12 mm, fillet radius = 3 mm

• Hole > simple > diameter = 11 mm • Mirror

c) WHEEL

Langkah Pemodelan :

• Sket (seperti gb.dibawah) dan revolve 3600

d) AXLE Langkah Pemodelan :

• Sket (seperti gb.dibawah) dan revolve 3600, chamfer 2x 450

MATERI III ASSEMBLY MODELLING

Lankah pemodelan :

• Insert component > browse > TOP PLATE

• Insert component > browse > AXLE SUPPORT 1 • Mate > concentric (lubang axle support 1 dan lubang top plate) • Mate > coincident (permukaan atas axle support 1 dan permukaan bawah

top plate)

• Insert component > browse > AXLE SUPPORT 2 • Mate > concentric (lubang axle support 2 dan lubang top plate) • Mate > coincident (perm atas axle support 2 dan perm bawah top plate)

• Insert component > browse > AXLE • Mate > concentric (lubang axle dan lubang axle support 1) • Mate > coincident (RP axle dan RP utama)

• Insert component > browse > WHEEL • Mate > concentric (lubang Wheel dan lubang axle support 1) • Mate > coincident (RP wheel dan RP axle)

MATERI III DRAWING

• Drawing > model view > browsing > buka file yang akan di drawing

• Drawing > projected view

• Drawing > detail view

• Drawing > section view

• Melengkapi dimensi dan keterangan yang dibutuhkan

Materi Solid Work

Documents

Transcript of Materi Solid Work