L2 tp

Network Security 1

Layer 2 Tunneling Protocol (L2TP)

• An example of network layer VPN: use IP packets to encapsulate Layer 2 frames

• Previous RFC (v2)- RFC2661 Layer Two Tunneling Protocol L2TP W.

Townsley, A. Valencia, A. Rubens, G. Pall, G. Zorn, B. Palter. August 1999 (PROPOSED STANDARD)

- A standard method for tunneling Point-to-Point Protocol (PPP) [RFC1661] sessions

- Note: L2TP has since been adopted for tunneling a number of other L2 protocols (e.g., Ethernet, Frame Relay, etc). L2TPv3 [RFC3931]

T. A. Yang

Network Security 2

Point-to-Point Protocol (PPP [RFC1661])

- PPP defines an encapsulation mechanism for transporting multiprotocol packets across layer 2 (L2) point-to-point links.

- PPP relies on the Link Control Protocol (LCP) for establishing, configuring, and testing the data-link connection.

- It has a family of Network Control Protocols (NCPs) for establishing and configuring different network-layer protocols.

- Typically, a user obtains a L2 connection to a Network Access Server (NAS) using one of a number of techniques (e.g., dialup POTS, ISDN, ADSL, etc.) and then runs PPP over that connection.

- Example: A customer uses a dialup modem or a DSL line to connect to the ISP or the company’s modem pool.Dial client (PPP peer) PPP NAS (e.g., ISP)

- In such a configuration, the L2 termination point and PPP session endpoint reside on the same physical device (i.e., the NAS).

T. A. Yang

Network Security 3

Layer 2 Tunneling Protocol• Types of L2TP Tunnels

1. Compulsory L2TP Tunneling

The client is completely unaware of the presence of an L2TP connection.

The L2TP Access Concentrator (LAC) is aware of L2TP.

Figure 12-3: (client) PPP + Data (LAC) L2TP + Data (LNS)

T. A. Yang

Network Security 4

Layer 2 Tunneling Protocol• Types of L2TP Tunnels (cont.)

2. Voluntary L2TP Tunneling

The client is aware of the presence of an L2TP connection.

The LAC is unaware of L2TP.

Figure 12-4: (client) PPP + L2TP + Data (LAC) L2TP + Data (LNS)

T. A. Yang

Network Security 5

Layer 2 Tunneling Protocol (cont.)

• L2TP

- L2TP extends the PPP model by allowing the L2 and PPP endpoints to reside on different devices interconnected by a packet-switched network (PSN).

- With L2TP, a user has an L2 connection to an L2TP access concentrator (LAC, e.g., modem bank, ADSL DSLAM, etc.), and the concentrator then tunnels individual PPP frames to the L2TP Network Server (LNS).Dial client (PPP peer) PPP LAC L2TP tunnel LNS

- This allows the actual processing of PPP packets to be separated from the termination of the L2 circuit.

T. A. Yang

Network Security 6

Layer 2 Tunneling Protocol (cont.)• A typical L2TP scenario (from RFC2661)

T. A. Yang

Network Security 7


RFC3931 Layer Two Tunneling Protocol - Version 3 (L2TPv3) J. Lau, Ed., M. Townsley, Ed., I. Goyret, Ed. March 2005 (PROPOSED STANDARD)

L2TPv3 defines the base control protocol and encapsulation for tunneling multiple Layer 2 connections between two IP nodes.

L2TPv3 consists of

(1) the control protocol for dynamic creation, maintenance, and teardown of L2TP sessions, and

(2) the L2TP data encapsulation to multiplex and demultiplex L2 data streams between two L2TP nodes across an IP network.

T. A. Yang

Network Security 8


• L2TP (according to TheFreeDictionary, http://computing-

dictionary.thefreedictionary.com/L2TP)

• A protocol from the IETF that allows a PPP session to travel over multiple links and networks. (Note: a limitation of L2TPv2)

• L2TP is used to allow remote users access to the corporate network.

• PPP is used to encapsulate IP packets from the user's PC to the ISP, and L2TP extends that session across the Internet.

• L2TP was derived from Microsoft's Point-to-Point Tunneling Protocol (PPTP) and Cisco's Layer 2 Forwarding (L2F) technology.

T. A. Yang

Network Security 9

Layer 2 Tunneling Protocol (cont.)• From Access Concentrator to Network Server

• The "L2TP Access Concentrator" (LAC) encapsulates PPP frames with L2TP headers and sends them over the Internet as UDP packets (or over an ATM, frame relay or X.25 network).

• At the other end, the "L2TP Network Server" (LNS) terminates the PPP session and hands the IP packets to the LAN. L2TP software can also be run in the user's PC.

• Carriers also use L2TP to offer remote points of presence (POPs) to smaller ISPs. Users in remote locations dial into the carrier's local modem pool, and the carrier's LAC forwards L2TP traffic to the ISP's LNS.

user original IP packet (p) PPP+p LAC L2TP+PPP+p LNS

• L2TP and IPsec• L2TP does not include encryption (as does PPTP), but is often used with

IPsec in order to provide virtual private network (VPN) connections from remote users to the corporate LAN.

T. A. Yang

Network Security 10

L2TP Operations• Assumptions: Compulsory tunneling

• The Procedure:1. The Client initiates a PPP connection to the LAC.

2. The LAC does LCP negotiation with the client, and challenges the client for authentication credentials.

3. The client supplies the credentials (such as user name, domain name, password).

4. The LAC uses the domain name to ascertain which LNS it needs to contact (in the case of multiple domains).

5. The LAC begins establishing an L2TP tunnel with the LNS.

• Two Stages of L2TP Tunnel Setup:1. Set up a control session between the LAC and the LNS.

2. Set up the actual L2TP tunnel for passing the data (aka. ‘creating the session’)

– Notes:

• Between a pair of LAC and LNS, there may exist multiple tunnels.

• Across a single L2TP tunnel, there may exist multiple sessions.

T. A. Yang

Network Security 11

L2TP Tunnel Setup (from RFC2661)

T. A. Yang

Network Security 12

L2TP Operations• Control Connection Establishment

- Securing the peer’s identity, identifying the peer’s L2TP version, framing, etc.

1.LAC SCCRQ (start-control-connection-request) LNS

2.LAC SCCRP (start-control-connection-reply LNS

3.LAC SCCN (start-control-connection-connected LNS

--------------------------------------------------------------------------------------

LAC ZLB ACK LNS

The ZLB ACK is sent if there are no further messages waiting in queue for that peer.

T. A. Yang

Network Security 13

L2TP Operations• Session Establishment

- A session may be created after successful control connection is established.

- Each session corresponds to a single PPP stream between the LAC and the LNS.

- Session establishment is directional:- Incoming call: The LAC asks the LNS to accept a session;

- Outgoing call: The LNS asks the LAC to accept a session

- Incoming Call Establishment:1. LAC ICRQ (Incoming-Call-Request) LNS

2. LAC ICRP (Incoming-Call-Reply LNS

3. LAC ICCN (Incoming-Call-Connected LNS

--------------------------------------------------------------------------------------

LAC ZLB ACK LNS

The ZLB ACK is sent if there are no further messages waiting in queue for that peer.

T. A. Yang

Network Security 14T. A. Yang

Network Security 15

L2TP Message Header

T. A. Yang

L2TP Control

Messages

(from RFC2661)


L2TP Authentication(from RFC2661)

Network Security 17

• Authentication, Authorization and Accounting may be provided by the Home LAN's Management Domain, which is behind the LNS.

• In that case, the LAC performs proxy authentication, by passing authentication information back and forth between the user and the LNS.

T. A. Yang

Network Security 18

L2TP Operations

• Case Studies:

- Setting up compulsory L2TP Tunneling

T. A. Yang

Network Security 19

L2TP Operations

• Case Studies (cont.)

- Protecting L2TP Traffic using IPsec in a compulsory tunneling setup

NOTE: L2TP encapsulation occurs before IPSec processing.

T. A. Yang

L2TPv3 Topology (from RFC3931)

• L2TP operates between two L2TP Control Connection Endpoints (LCCEs), tunneling traffic across a packet network.

• There are three predominant tunneling models in which L2TP operates: LAC-LNS (or vice versa),

LAC-LAC, and

LNS-LNS.


L2 tp

Education

Transcript of L2 tp