KYOTO COLLECTION...THESE ASSEMBLY FITTINGS FOR THE KYOTO COLLECTION INSTRUCTIONS APPLY TO THE...
Transcript of KYOTO COLLECTION...THESE ASSEMBLY FITTINGS FOR THE KYOTO COLLECTION INSTRUCTIONS APPLY TO THE...
KYOTO COLLECTION
ASSEMBLY INSTRUCTIONS
FITTINGS FOR THE KYOTO COLLECTIONTHESE ASSEMBLY INSTRUCTIONS APPLY TO THE FOLLOWING MODELS:
• Kyoto Bed, Kyoto Bed with Headboard
• Kumo Bed, Kumo Bed with Headboard
• Kobe Bed, Kobe Bed with Headboard
3 X NUTS*
3 X DOME HEAD BOLT*
4 X WASHERS
1 X ALLEN KEY
3 X HALF
MOONWASHER*
1 X SPANNER
4 X SCREWS
6 X FLAT HEAD
BOLT
1.Place the rails on the legs as
shown, then screw in the flat head bolts with the allen key.
* 2 IF SINGLE BED
(only additional tool required is a Philips head screwdriver):
* Please note - All timber sections have numbers pressed into the timber where they are tied together to indicate how they should be positioned (e.g side
rail hole1 connects to leg rail hole1).
* Please note - Single bed bases will not include a centre rail
2.Using the dome headed
bolts connect the headboard panel to the side/centre rails
- secure with the half moon washers and nuts. Tighten
with the spanner.
3.
Position the head end panel and foot end panel - secure using the small
washers and screws provided.* If you have ordered a bed without a headboard please
ignore this step.
4.
* Please note - if you have ordered a standard single (90cm) or super-king (180cm) bed base you will also
receive a set of double slats with sliders. These slats are for holes 4-9 from the head of the bed base.
Place the end caps on the sprung slats and attach
(centre of the gently curved slats should be upwards)
THANK YOU FOR BUYING A BED FROM
DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP T: 0114 272 1984
E: [email protected] W: WWW.NATURALBEDCOMPANY.CO.UK