KX-TDE/NCP Version 7 Product Information Rev DD June 04, 2013 Specifications and schedule are...

KX-TDE/NCP Version 7Product Information

Rev DD June 04, 2013

Specifications and schedule are subject to change without notice.Specifications and schedule are subject to change without notice.

Panasonic System NetworksPanasonic System NetworksPBX SE team PBX SE team

Official software release of mass production version : 2013 June Official software release of mass production version : 2013 June Mass production change : 2013 AugustMass production change : 2013 August

2

Feature List

No. Feature

1 New IP-PT KX-NT5xx is supported.

2 Outgoing call log and incoming call log for extension call

3 Tenant based extension directory

4 Transfer to trunk after call is answered by cellular phone.

5&6 Other improvement

3

Revision

Edition No. Revision Date

AA - 1st draft for PSN group internal study Dec 06, 2012

BB 4-5 Example was added. Dec 15, 2012

CC 4-2 This feature is available for not only “Keep Ring” Fwd but also other Fed.

Jan 24, 2013

DD 4-6 This page was removed. June 04, 2013

5&6 Other improvements were added. June 04, 2013

4

KX-NT5xx IP PT

5

New IP-PT KX-NT5xx is supported.- KX-NT5xx hardware is based on KX-UT which supports improved hands-free functionality compare to KX-NT3xx.- But software is based on KX-NT3xx to support full PBX features.

1-1. KX-NT5xx - Specifications Version 7NT5xx

- BT headset feature is not available for KX-NT543 and NT546.- BT headset feature available for KX-NT560 without option.- EHS (Electronics Hook Switch) is available for all KX-NT5xx.

KX-NT543 　　　　　　　　 KX-NT546 KX-NT5603-line LCD 6-line LCD

6

Difference from KX-NT3xx- KX-TDA0470 IPEXT16 card does not support KX-NT5xx. Therefore one KX-TDE or KX-NCP can support maximum 128 KX-NT5xx by LAN port on MPR card. KX-NS1000 is recommended for more than 128 KX-NT phones. - Encryption is not supported.- Add-on key module is not available for KX-NT5xx.- Handset cord is longer.

1-2. KX-NT5xx - Conditions

KX-NT346 with

KX-NT305KX-NT346 with

KX-NT303

KX-NT5xxKX-UT580mm

KX-NT3xxKX-DT370mm

For example, hotel front staff cango to printer during talking.

Model Supported by

KX-NT321KX-NT343KX-NT346

MPRand

IPEXT16

KX-NT366 MPR

KX-NT5xx MPR

Add-on 12-key Add-on 60-key

Version 7NT5xx

7

Difference from KX-UT- SBC cannot be used because not SIP based.- DTMF Tone cannot be sent to other IP extension during P2P talking.- Quantity of key is increased to support full PBX features.

1-3. KX-NT5xx - Conditions

⑨ Message ⑩ Pause ⑪ Flash ⑫ Redial

⑬ Auto Ans ⑭ Conf ⑮ Transfer ⑯ Auto Dial

⑰ Fwd/DND Hold⑱ Cancel⑲ Intercom⑳

⑳ SP-Phone

< KX-NT543 / KX-NT546 >

Version 7NT5xx

8

Call Log for Extension Call

9

HQ7-81

101 102 105

Outgoing call log and redial are available for extension call also by programming.

2-1. Call Log for Extension Call Version 7for PT

IP Network

Branch7-80

101

Public Telephone Network

09-8765-4321 050-1234-5678

<Dial using Log>0/9-09876543210/9-050123456787-80-101105102

102 can be saved newly using TDE-NCP version 7. Other dials are saved using TDE-NCP any version.

“Store” works for extension call also.

10

HQ7-81

101 102

Incoming call log is available for extension call also by programming.

2-2. Call Log for Extension Call

IP Network

Branch7-80

101

Public Telephone Network

050-1234-5678

<Call back using Log>0/9-09876543210/9-050123456787-80-101102

102 and 80101 can be saved newly using TDE-NCP version 7. Other dials are saved using TDE-NCP any version.

09-8765-4321

Version 7for PT

11

Programming- This feature is enabled for incoming call and outgoing call separately using system optional programming.- Default is “Enable”. - Specification of “Disable” is same as TDE-NCP version 6 or before.


12

TDE-NCP version 7 Outgoing Call Log : Disable for Extension Call orTDE-NCP version 6 or before

=> Same number is logged.

TDE-NCP version 7 Outgoing Call Log : Enable for Extension Call

Condition- When outgoing call log is available for extension call, old same phone number is deleted from outgoing call automatically. This is applied to both extension call and trunk call.

2-4. Call Log for Extension Call

If call 105, old 105 is deleted.Other dials are kept.

This improvement is not applied to incoming call log because “How often” is important.

Version 7for PT

13

Condition- Call log for extension call does not wok for system wireless. However following new DECT handset can receive call log for extension call. KX-TCA185 / KX-TCA285 / KX-TCA385


14

Tenant basedExtension Directory

15

Extension directory can be limited for same tenant user onlyby programming.

3-1. Tenant Extension Directory

101 102 103 104 105 Ann Bill Catherine Diana Elizabeth

111 112Andrew Charles

Tenant 1 : ABC Trading Tenant 2 : Royal Travel

Extension Directory does NOT display Andrew and Charles,when limitation is activated.

Extension Directory displaysAndrew and Charles also,when limitation is NOT activated.

Version 7Tenant

16

Programming- This feature is enabled using tenant programming. All Tenant : Can see directory of all extension 　　 (Default : Same as TDE/NCP version 6) Each Tenant : Can see directory of extension in same tenant only

3-2. Tenant Extension Directory Version 7Tenant

17

Conditions- DSS key is not limited for other tenant.- However flexible key programming can be limited to “one touch dial only” using extension programming. PT programming also can be restricted using COS programming.


Above programming is available for KX-TDA/TDE/NCP/NS any version.

TDA/TDENCP/NS

Any version

18

Conditions - Cont- Extension call and call pick-up can be restricted for other tenant using COS programming. This restriction is applied to any operation regardless DSS key.


Above programming is available for KX-TDA/TDE/NCP/NS any version.

COS-1/2/3 cannot call COS-4/5.COS-4/5 cannot call COS-1/2/3.COS-4/5 can call COS-4/5.

<More Information>COS-1/2 can call COS1/2.COS-1 cannot call COS-3.COS-2 can call COS-3. COS-3 can call COS-1/2/3. COS-1 : Employee COS-2 : Manager COS-3 : President Employee cannot call president.But president can call employee.

TDA/TDENCP/NS

Any version

101 102 103 104 105 Ann Bill Catherine Diana Elizabeth

111 112Andrew Charles

COS-1 COS-2 COS-1 COS-2 COS-3 COS-4 COS-5

19

Cellular as Extension

20

Cellular phone users can transfer a call to extension in other PBX and outside telephone number, as well as extension in same PBX, after they received incoming call.

4-1. Transfer from Cellular

Office

101 102 105

Public Telephone or Cellular Network

09-8765-4321Customer

050-1234-5678

105 and 050-1234-5678 can be destination of transferred newly using TDE-NCP version 7.Extension number such as 102 is destination of transfer using TDE-NCP any version.

080-8888-4444Cellular

Dial # 102 or # 105 or # 0/9-050-1234-5678to transfer. # works as “Flash” of SLT.

In Russia, TDE to TDE connection using QSIG is very popular as solution for more than 1000 extensions.TDE V6 or before was strange for user.

- Transfer to 102 : OK- Transfer to 105 : Not OK

Version 7 Cellular

21

Programming - Summary- Cellular phone has to be Fwd destination of extension. This feature is available for “keep ringing” mode also. Or cellular phone has to be member of ICD group using virtual PS.- DISA connection has to be enabled to detect DTMF # and transfer destination. - ESVM card or MSG card on OPB3 card - 2-ch SVM circuit on MPR card - Activation key is required to detect DTMF #. KX-NCS3910 for KX-NCP KX-NCS4910 for KX-TDE100-200 KX-NCS4950 for KX-TDE600

- 0/9 + Caller ID of cellular phone has to be assigned as extension using system speed dial programming. COS of the extension is applied to transfer call trunk for transferring. (Same programming as Automatic walking COS through DISA)- If caller ID of cellular phone is not assigned, COS of Trunk Group (trunk to call cellular phone) is applied.


080-8888-4444Cellular

101Keep Ringing

even after Fwd

Fwd

Version 7 Cellular

22

Programming - 1- Cellular phone has to be Fwd destination of extension. This feature is available for “keep ringing” mode also using Fwd No answer feature with keep ringing mode.


080-8888-4444Cellular

101Keep Ringing

even after Fwd

Fwd

Version 7 Cellular

23


Programming - 2- DISA connection has to be enabled to detect DTMF # and transfer destination.

Version 7 Cellular

24

Programming - 3- 0/9 + Caller ID of cellular phone has to be assigned as extension using system speed dial programming. COS of the extension is applied to transfer call trunk for transferring. (Same programming as Automatic walking COS through DISA)


080-8888-4444Cellular

101

If extension cannot call international, paired cellular phone cannot transfer a call to international.

Version 7 Cellular

25

5-1. Caller ID for Cellular

Caller ID of caller can be displayed on cellular phone, even if call is redirected from PBX to cellular phone. This service is available by some ISDN or SIP network in Europe.If incorrect “0” or “00” is displayed always, it can be removed by programming. See next page for programming.

Office

Cellular Network

Customer03-4444-5555

EXT 101092-123-4321

EXT 102092-123-4322

ISDN/SIP Network

080-888-7777

Dial092-123-4322

00344445555

034445555

“0” can be removed.

Version 7 Cellular

26

5-2. Caller ID for Cellular

Programming2.System – 9. System Options – Option 7

Version 7 Cellular

27

SIP Trunk Improvement

28

6. SIP Trunk 6. SIP Trunk Version 7Version 7SIPSIP

“From Header” type is supported newly to receive caller ID from some SIP provider correctly. ”P-Asserted-Identity Header” (Default) / “From Header”

Even when not only number but also character is sent as DDI number from SIP provider, DDI feature works from version 7.Other features are also improved for SIP from version 7.

29

Thank you !

KX-TDE/NCP Version 7 Product Information Rev DD June 04, 2013 Specifications and schedule are...

Documents

Transcript of KX-TDE/NCP Version 7 Product Information Rev DD June 04, 2013 Specifications and schedule are...