English

By Bjørnar, Øystein and Thomas

Installation of heating cables, a light and an outlet with a thermostat and two pole circuit breaker

The Fuse box The fuse box wiring starts with three

phases. They pass trough the main fuse and the

kW/h measurer. There is no earth switch in this box since

every circuit has its own fuse with a built in earth switch.

The fuses job is to protect the cable from getting fried during over charge and short circuit.

On the top we have the earthtrack

Wall box

These red boxes are used as a mount point for switches, thermostat, dimmers and timers.

If you look on the box on the right the one with the thermostat there is two yellow and green wires. There is a red cap on them it is called a Torex and it twists two or more wires togetter to create a good connection.

Heating cables

These are heating cables. They are installed under the floor. After installation a mass of some

substance is put on top before the floor is covered.

You need to be carful so you don’t break the cable.

We need Mario

In this picture we found an error. The pipe is not properly attached

to the box. If this happened in real life then

we are screwed, then we can not pull the wire through the pipe.

The Light

In these red boxes we can also attach light sockets. Usually we use the white boxes with a bit wider radius and a bit shorter width.

>>>>>>>>>>>>>>>>>>>>>>>

Fuse > Installation box mounting > piping >

That concludes our presentation