PARTS MANUALSECTION 16

Published 04/11 MATERIAL HANDLING PARTS MANUAL

HT210

HAY TEDDER

©2009 Alamo Group Inc.

PARTS ORDERING GUIDE

The following instructions are offered to help eliminate needless delay and error in pro-cessing purchase orders for the equipment in this section.

1. The Parts Section is prepared in logical sequence and grouping of parts that belong to the basic machine featured in this manual. Part Numbers and Descriptions are given to help locate the parts and quantities required.

2. The Purchase Order must include the name and address of the person or organiza-tion ordering the parts, who should be charged, and if possible, the serial number of the machine for which the parts are ordered.

3. The Purchase Order must clearly list the quantity of each part, the complete and correct part number (be sure to include all periods), and the basic name of the part.

4. The Manufacturer reserves the right to substitute parts where applicable.

5. Some parts are unlisted items which are special production items not normally stocked and are subject to special handling. Request a quotation for such parts before sending a Purchase Order.

6. The Manufacturer reserves the right to change prices without prior notice.

For maximum safety and to guarantee optimum product reliability, always use genuine BUSH HOG Parts. The use of inferior replacement parts may causepremature or catastrophic failure which could result in serious injury or death.Direct any questions regarding parts to:

BUSH HOG2501 Griffin Ave. Selma, AL 36703www.bushhog.comContact Us800-304-2836

To the Owner/Operator/Dealer

All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-mindedoperator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer hasdesigned this implement to be used with all its safety equipment properly attached to minimize the chance ofaccidents.

BEFORE YOU START! Read the safety messages on the implement and shown in your manual. Observe the rulesof safety and common sense!

WARRANTY INFORMATION:Read and understand the complete Warranty Statement found in this Manual. Fill out the Warranty RegistrationForm in full and return it to within 30 Days. Make certain the Serial Number of the Machine is recorded on theWarranty Card and on the Warranty Form that you retain.

LIMITED WARRANTY

Bush Hog warrants to the original purchaser of any new Bush Hog equipment, purchased from an authorized BushHog dealer, that the equipment be free from defects in material and workmanship for a period of one (1) year fornon-commercial, state and municipalities’ use and ninety (90) days for commercial use from date of retail sale. Theobligation of Bush Hog to the purchaser under this warranty is limited to the repair or replacement of defectiveparts.

Replacement or repair parts installed in the equipment covered by this limited warranty are warranted for ninety(90) days from the date of purchase of such part or to the expiration of the applicable new equipment warrantyperiod, whichever occurs later. Warranted parts shall be provided at no cost to the user at an authorized Bush Hogdealer during regular working hours. Bush Hog reserves the right to inspect any equipment or parts which areclaimed to have been defective in material or workmanship.

DISCLAIMER OF IMPLIED WARRANTIES & CONSEQUENTIAL DAMAGESBush Hog’s obligation under this limited warranty, to the extent allowed by law, is in lieu of all warranties, implied orexpressed, INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR APARTICULAR PURPOSE and any liability for incidental and consequential damages with respect to the sale oruse of the items warranted. Such incidental and consequential damages shall include but not be limited to:transportation charges other than normal freight charges; cost of installation other than cost approved by BushHog; duty; taxes; charges for normal service or adjustment; loss of crops or any other loss of income; rental ofsubstitute equipment, expenses due to loss, damage, detention or delay in the delivery of equipment or partsresulting from acts beyond the control of Bush Hog.

THIS LIMITED WARRANTY SHALL NOT APPLY:1. To vendor items which carry their own warranties, such as engines, tires, and tubes.

2. If the unit has been subjected to misapplication, abuse, misuse, negligence, fire or other accident.

3. If parts not made or supplied by Bush Hog have been used in connection with the unit, if, in the sole judgementof Bush Hog such use affects its performance, stability or reliability.

4. If the unit has been altered or repaired outside of an authorized Bush Hog dealership in a manner which, in thesole judgement of Bush Hog, affects its performance, stability or reliability.

5. To normal maintenance service and normal replacement items such as gearbox lubricant, hydraulic fluid, wornblades, or to normal deterioration of such things as belts and exterior finish due to use or exposure.

6. To expendable or wear items such as teeth, chains, sprockets, belts, springs and any other items that in thecompany’s sole judgement is a wear item.

NO EMPLOYEE OR REPRESENTATIVE OF BUSH HOG IS AUTHORIZED TO CHANGE THIS LIMITEDWARRANTY IN ANY WAY OR GRANT ANY OTHER WARRANTY UNLESS SUCH CHANGE IS MADE INWRITING AND SIGNED BY BUSH HOG’S SERVICE MANAGER, 2501 GRIFFIN AVE., SELMA, ALABAMA36703.

Record the model number, serial number and date

purchased. This information will be helpful to your

dealer if parts or service are required.

MAKE CERTAIN THE WARRANTY

HAS BEEN FILED WITH BUSH HOG

SELMA, ALABAMA

MODEL NUMBER ________________________________

SERIAL NUMBER ________________________________

DATE OF RETAIL SALE ___________________________

BUSH HOG/MATERIAL HANDLING REPAIR PARTS MANUAL APRIL, 2011

ALPHABETICAL TABLE OF CONTENTS

HT210 HAY TEDDER

ITEM PAGE NUMBER

Center Section. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16-1-2, 16-1-3

Decals - Bush Hog Marking. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16-1-5

Drawbar & Guard Assemblies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16-1-1

IID Assembly w/Clutch, 540 RPM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16-1-4

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Inside Back Cover

BUSH HOG/MATERIAL HANDLING REPAIR PARTS MANUAL APRIL, 2011

DRAWBAR & GUARD ASSEMBLIES

MODEL HT210

REF. PART

NO. NO. DESCRIPTION QTY.

1 3670203 Drawbar 12 3670201 R.H. Lateral Guard 13 3670202 L.H. Lateral Guard 14 3670204 Handle 15 3677503 Tie Rod Screw 16 3677504 Pin 17 3670205 Fork 18 3677505 Pin 19 3677506 Pin 110 70485 Cotter Pin 611 70349 Roll Pin 112 001465 Grease Fitting 113 3676775 Plug 414 70209C Serrated Washer 415 00762462 Bolt 4

16-1-1

BUSH HOG/MATERIAL HANDLING REPAIR PARTS MANUAL APRIL, 2011

CENTER SECTION

MODEL HT210

16-1-2

BUSH HOG/MATERIAL HANDLING REPAIR PARTS MANUAL APRIL, 2011

REF. PART

NO. NO. DESCRIPTION QTY.

1 3676400 Gearbox Housing 12 3676401 LH Rotor Axle Housing 13 3676402 RH Rotor Axle Housing 14 --------- Shaft Guard 15 70093C Locknut 26 00755934 Nut 27 3676778 Guard, IID 18 3676403 Gearbox Lock Plate 19 3676800 Oil Seal 110 02958784 Bolt 211 --------- Bearing 112 3676404 Shaft 113 710640 Key, Rnd End 214 0600004 Bearing 115 3676405 Pinion Gear 116 3678401 Stud Bolt 217 3676406 Drive Shaft 118 710630 Key, Rnd End 219 --------- Oil Plug 220 3676408 Crown Gear 121 701611C Lockwasher 222 3677422 Spring Tine 1223 00772648 Nut 3624 3677512 Tine Plate 1225 00766177 Bolt 1226 3677564 Tine Arm (New Style) (Repl,s 3677513) 1227 3676801 Oil Seal 128 3236001 Bearing 129 3676802 Oil Seal 130 00754565 Bolt 1231 70209C Washer, Serrated 1232 3676409 Pinion Gear 233 703616W Roll Pin 434 703417W Roll Pin 435 3636003 Bearing 236 3676410 Crown Gear 237 3676411 Rotor Shaft 238 3676412 Tine Disc 239 3676000 Bearing 240 613713C8 Bolt 1241 00754565 Bolt 1242 00766457 Grease Fitting 243 3676900 Gasket 244 3676901 Shim 245 3676413 Hub 246 00766457 Grease Fitting 247 3676001 Bearing 248 3676902 Shim 249 3676903 Gasket 250 3670230 LH Support Spindle 151 3670231 RH Support Spindle 152 3676700 Inside Dust Cover 253 3676002 Bearing 454 3677800 Tube 255 3677801 Tire 256 3677600 Rim 257 3677514 Spacer 258 3676701 Outer Dust Cover 259 3670101 Tire Assembly 260 3038445 Nut 270 3238201 Snap Ring 171 3676779 Plug (Machines Without Guards Only) 472 701515C Washer, Flat 2

CENTER SECTION

MODEL HT210

16-1-3

BUSH HOG/MATERIAL HANDLING REPAIR PARTS MANUAL APRIL, 2011

IID ASSEMBLY W/CLUTCH, 540 RPMMODEL HT210

16-1-4

REF. PARTNO. NO. DESCRIPTION QTY.

1 2516536 Yoke, Twist Lock 12 --------- Push Pin Kit 23 00773138 Cross Kit 24 1416448 Circlip (Part of 3) 85 1416449 Grease Fitting (Part of 3) 26 1416450 Outer Tube Yoke 17 703517W Roll Pin 18 3616400 Outer Tube 19 00756004 Decal, Danger - Shield Removed (Part of 8) 1

10 --------- Outer Bearing 111 2516541 Outer Cone 112 1416465 Chain 113 --------- Outer Shield Tube 114 00756005 Decal, Danger - Rotating Driveline (Part of 13) 115 --------- Inner Shield Tube 616 2516544 Inner Cone 517 --------- Inner Bearing 118 --------- Inner Tube 319 1416455 Inner Tube Yoke 220 --------- Roll Pin 821 --------- Housing w/Yoke 422 --------- Hub 623 --------- Retaining Washer 124 --------- Circlip 125 --------- Ratchet Tooth 1626 --------- Grease Fitting 127 --------- Torque Limiter, Complete (Includes Items 21-26 & 2) 128 3616406 Front IID Half Shaft w/Shield 129 3616407 Rear IID Half Shaft w/Clutch & Shield 130 3676430 IID Assembly w/Clutch, Complete 1

BUSH HOG/MATERIAL HANDLING REPAIR PARTS MANUAL APRIL, 2011

1

4

7

10

2

5

8

11 12

6

3

9

13

REF. PART

NO. NO. DESCRIPTION QTY.

1 50068923 Decal, Model HT210 22 00786980 Decal, Genuine Bush Hog Parts 13 999001 Decal, Warning - Tractor Weight 14 00725746 Decal, Peligro 15 3678303 Decal, Danger - Rotors 16 999200 Decal, General Warning - All Unit 17 00756004 Decal, Danger - Guard Missing 18 00763977 Decal, Important - Notice to Owner 19 00776031 Canister, Parts Manual 1

10 03200347 Emblem, SMV 111 2738332 Decal, Red Oblong Reflector 112 2738333 Decal, Yellow Oblong Reflector 113 50063360 Decal, Bush Hog 8” 214 00756005 Decal, Rotating Driveline (Not Shown) 1

DECALS - BUSH HOG MARKING

MODEL HT210

16-1-5