Hardware Transmit Lockout for the TS-590S and ... - kkn.net
2
Hardware Transmit Lockout for the TS-590S and the TS-590SG Steve London, N2IC Locate Q904 on the foil side of the TX-RX board. The TX-RX board is accessed by removing the bottom cover of the TS-590. The board must be removed to access the foil side. In the attached drawings, Q904 is shown, circled in the top, left corner. Connect 2 wires to Q904. One wire to the base, the other to the emitter. To inhibit transmit, short the two wires together using a relay or other means. Do not short either wire to ground. Thanks to E7DX and S55M for this information.
Transcript of Hardware Transmit Lockout for the TS-590S and ... - kkn.net
![Page 1: Hardware Transmit Lockout for the TS-590S and ... - kkn.net](https://reader033.fdocuments.us/reader033/viewer/2022042013/625599326ca15f0cb2521f91/html5/thumbnails/1.jpg)
Hardware Transmit Lockout for the TS-590S and the TS-590SGSteve London, N2IC
Locate Q904 on the foil side of the TX-RX board. The TX-RX board is accessed by removing the bottom cover of the TS-590. The board must be removed to access the foil side. In the attached drawings, Q904 is shown, circled in the top, left corner.
Connect 2 wires to Q904. One wire to the base, the other to the emitter.
To inhibit transmit, short the two wires together using a relay or other means. Do not short either wire to ground.
Thanks to E7DX and S55M for this information.
![Page 2: Hardware Transmit Lockout for the TS-590S and ... - kkn.net](https://reader033.fdocuments.us/reader033/viewer/2022042013/625599326ca15f0cb2521f91/html5/thumbnails/2.jpg)
TS-590S