FCM 100/ TCM 100 · FCM Dynamic Bending test machine and TCM Torsion Test machine have been...
Transcript of FCM 100/ TCM 100 · FCM Dynamic Bending test machine and TCM Torsion Test machine have been...
Bending and torsion test machines
... the referencefor ISO standard
quality test ...
FCM 100/ TCM 100FCM 100/ TCM 100
FCM Dynamic Bending test machine and TCMTorsion Test machine have been designed forsmart cards post production quality control.These machines can be used in manual, step-by-step or automatic mode. A backward cycle
counter enables automatic switch off at theend of the programmed sequence. Mechanicalstress is applied on the cards in accordancewith ISO 7816/1 standard. Cycle period conforms to the ISO standard: 1 cycle/2s.
• Manual or automatic mode
• Test in accordance with ISO 7816/1 standard
• Adjustable stress (bending or torsion)
FEAFEATURESTURES
FCM - A4 - Sept 07.qxp 10/17/2007 10:23 AM Page 1
FCM 100 / TCM 100 Technical Specifications
FCM - BENDING MACHINE
This equipment applies horizontal and verticalbending stress to the tested cards. The cards areplaced between 2 sets of guide rails:
• 5 cards in vertical position in the front guide rails• 8 cards in horizontal position in the back guide
rails
The upper guide rail oscillates due to the action ofan actuator against the lower fixed rail, thus bending the cards.
TCM - TORSION MACHINE
This equipment applies right and left longitudinal torsion stresses. The cards are placed in the vertical position in the grooves of 2 guide rails.
The upper guide rail oscillates horizontally due toan actuator acting upon the lower fixed rail, thusapplying a torsion to the cards.
GENERAL CHARACTERISTICS
PerformanceFCM
• 13 cards processed at the same time
• Stress adjustment range- from 2 to 20 mm on the long side of the card- from 1 to 10 mm on the short side of the card.
TCM
• 10 cards processed at the same time
• Torsion adjustment range- From 0 to 30°
Dimensions
FCM / TCM
• Length: 770 mm / 350 mm• Width: 320 mm / 320 mm• Height: 430 mm / 300 mm• Weight: 15 kg / 10 kg
Electrical
• 230v / 1 ph / 500w
Website: www.nbstech.com Email: [email protected]
Corporate Headquarters
703 Evans AvenueToronto, OntarioM9C 5E9 Canada tel: +1 416.621.1911fax: +1 416.621.8875
Contact our NBS smart card manufacturing experts for full details on this and other smart card manufacturing products at:
Zone Industrielle - Avenue Villevieille13106 Rousset Cedex Francetel: +33 (0) 442.532.772 fax: +33 (0) 442.532.641
©28-Sept-07 NBS Technologies Inc. Specifications are subject to change without notice. All rights reserved. All brand and product names are the trademarks or registered trademarks of their respective holders.
FCM - A4 - Sept 07.qxp 10/17/2007 10:23 AM Page 2