HOW TO ADD A PE

RFECT

TRANSITION TO

YOUR

FINAL C

UT PRO X

FOOTAGE.

B Y EZ E K I E

L KI N

G S T O N - I NY A N G

STEP 1. First step to being able to add

you effects is pretty obvious, you have to switch on your Computer/Laptop device.

STEP 1.5Now that you have turned on your computer (Like you didn’t

know that you had to) you now have to do the next daunting step. Download Final Cut Pro X. (YESSSSSS….I know its another troll type step but you will be surprised in how many people may try to type Final Cut Pro X in the finder but not have it downloaded.)

STEP 2(Finally we have escaped the troll slides.) So the next step is to

open up your Final Cut Pro X. As simple as it sound you actually have to do it to edit.

STEP 3Now this is the part where we actually start doing some serious

stuff (FINALLY). You now get the two footages that you want to transition between and import them into Final Cut Pro X.

STEP 4Now you have added in the clips that you want to transition in-

between you now want to go to the transition section Final Cut Pro X.

STEP 5From this transition list you pick one of the transitions that you

want to be used and drag it in-between the two footages that you wanted to transition between.

TRANSITION COMPLETEIf you have followed these steps carefully (its pretty hard to

mess up these steps because they are pretty simple) you should now have a very clean and effect transition in between both of the clips that you have chosen.