Download Pass4sure 200-601 Question Answers to Success in career

7
TestsChamp Cisco 200-601 Exam Name: Managing Industrial Networks for Manufacturing with Cisco Technologies Product: Demo We also provide Practce Test Sofwaree Online Practce Test Engine and Video Tutorials. Visit our website to purchase full version of Practce Test of Video Tutorials & to try practce test sofware for free: http://www.testschamp.com/200-601.html

Transcript of Download Pass4sure 200-601 Question Answers to Success in career

TestsChamp

Cisco

200-601

Exam Name:

Managing Industrial Networks for Manufacturing with Cisco Technologies

Product: Demo

We also provide Practce Test Sofwaree Online Practce Test Engine andVideo Tutorials. Visit our website to purchase full version of Practce Test

of Video Tutorials & to try practce test sofware for free:

http://www.testschamp.com/200-601.html

We also ofee PRACTICE TEST SOFTWARE with Actual Exam Questoos - Tey feee demo feom oue Website

Page | 2

Version: 7.0

Questoo: 1

Given the CIA triad elementse which ensures frst that the data is encrypted and securee second thatthe data is trustworthye and third that the data is accessible by those who need it?

A. CIAB. ICAC. ACID. CAI

Aoswee: A

Questoo: 2

Refer to the exhibit. The Robot Cell is in a botling plant. This cell environment needs to consider highfexe EMIe and possible exposure to moisture. Which physical media components need to beconsidered to prevent network degradaton or interruptons?

A. Strandede shielded wire with an industrial jacket and M12 connectorsB. Solide unshielded commercial jacket wiree and M12 connectorsC. Strandede unshielded wire with an industrial jackete and commercial grade RJ45 connectorsD. Solide shielded wire with commercial grade jackete and commercial grade RJ45 connectors

Aoswee: A

Questoo: 3

Refer to the exhbit. Which three elements would enable high availability and predictableperformance for a moton control applicaton spread across two switches (with video and I/O trafci?(Choose threei

We also ofee PRACTICE TEST SOFTWARE with Actual Exam Questoos - Tey feee demo feom oue Website

Page | 3

A. Confgure QoS to give PTP trafc the highest priorityB. Fiber optc uplinksC. Redundant uplinksD. Confgure QoS to give I/O trafc the highest priorityE. Copper uplinksF. Interconnect the two switches

Aoswee: A, B, C

Questoo: 4

You have been tasked to design an Ethernet network capable of Moton control with cycle tmes notto exceed 1ms. In order to create a more deterministc networke what characteristc/s should youprimarily focus on?A: Latency and JiterB: Redundancy and high availabilityC: Explicit and Implicit messagingD: This cycle tme is not possible on an Ethernet networkE: Gigabit port speed

Aoswee: A

Questoo: 5

Refer to the exhibit.

We also ofee PRACTICE TEST SOFTWARE with Actual Exam Questoos - Tey feee demo feom oue Website

Page | 4

CIP Implicit messages from I/O#1 are being marked IP DSCP 47 by the endpoint and this marking istrusted by L2SW4. L2SW4 is confgured to map DSCP 47 to output queue 1 threshold 1. You havereceived feedback that some of these messages are not being received. Executng the show mlsinterface GigabitEthernet statstcs command on L2SW4 results in: L2SW4# show mls interface GigabitEthernet 1/1 statstcs<output omiteddoutput queues dropped:queue:                 threshold1          threshold2          threshold3queue 0                             0                          0                         0queue 1             309232345                      450                         0          queue 2                         300                        10                         0                             queue 3                           91                          0                         0 Repeatng this command results in the counters incrementng for queue 1 threshold 1. What are twooptons for reducing the packet loss on this interface while preserving the end-to-end DSCP marking?(Choose twoi

A. Confgure I/O#1 to mark this trafc with a diferent DSCP that is mapped to a less congested queueB. Increase the bufer allocaton for input queue 1C. Increase the bufer allocaton for output queue 1D. Alter the service policy to police to a higher CIRE. Change the egress queue map on L2SW4 to map this trafc to a less congested queue

Aoswee: C, E

Questoo: 6

It is common to use Resilient Ethernet Protocol (REPi on the manufacturing foor as a resiliencyprotocole as opposed to the Enterprise where it is not generally deployed. What are two reasons whyREP is more suitable for the plant foor? (Choose twoi

A. REP is only supported on Industrial Ethernet switchese it is not supported on Catalyst switches.B. REP converges faster than Spanning Treee allowing for greater network availability.C. REP supports Industrial Ethernet protocols beter because it moves the packets faster.D. Running dual cables from access switches to an aggregaton switch can have a much higher cost on

We also ofee PRACTICE TEST SOFTWARE with Actual Exam Questoos - Tey feee demo feom oue Website

Page | 5

the plant foor than in the Enterprise and running a ring protocol like REP provides resiliency at alower cost.E. Industrial protocols can be negatvely impacted by the number of nodes the Ethernet frametraversese REP provides a topology with no more than 3 nodes for any data path.

Aoswee: B, D

Questoo: 7

Which fve are characteristcs that describe Cisco Industrial switches? (Choose fvei

A. Din rail mountB. 19 inch rack mountC. FanlessD. FansE. Swappable SD fash cardF. Alarm relayG. -5ºC to 45ºC operatng environmentH. ProfNET conformance class C compliance

Aoswee: A, B, C, E, F

Questoo: 8

Which selecton is a reason why IGMP snooping should be confgured on a switched network?

A. IGMP snooping populates the snooping table with the results of DHCP requests and can be usedby Dynamic ARP Inspecton to block IP spoofng atacks at Layer-2.B. IGMP snooping verifes the source IP address of every IPv4 packet to ensure that it hasn't beenoriginated from a port diferent than its return path.C. IGMP snooping is used to flter ping requests and results to avoid overfowing the MAC addresstable of the switch.D. IGMP snooping allows a Layer-2 switch to limit the transmission of multcast frames to only theports that have members of the relevant IGMP group.

Aoswee: D

Questoo: 9

Refer to the exhibit.

Which three optons are needed to confgure NAT on router GW so PC1 and PC2 will be able to ping203.0.113.1? (Choose threei

We also ofee PRACTICE TEST SOFTWARE with Actual Exam Questoos - Tey feee demo feom oue Website

Page | 6

A. interface Ethernet0 ip nat insideinterface Ethernet1 ip nat outsideB. ip access-list standard ACL_NAT permit 10.1.1.0 0.0.0.255C. ip nat inside source statc tcp 10.1.1.0 80 interface Ethernet1 80D. interface Ethernet0 ip nat outsideinterface Ethernet1 ip nat insideE. ip nat inside source list ACL_NAT interface Ethernet1 overloadF. ip access-list extended ACL_NAT permit tcp 10.1.1.0 0.0.0.255 any eq 80

Aoswee: A, B, E

We also ofee PRACTICE TEST SOFTWARE with Actual Exam Questoos - Tey feee demo feom oue Website

Page | 7

THANKS FOR TRYING THE DEMO OF OUR PRODUCT

Visit Our Site to Purchase the Full Set of Actual 200-601 Exam Questonswith Answers.

http://www.testschamp.com/200-601.html

We also provide Practce Test Sofwaree Online Practce Test Engine andVideo Tutorials. Visit our website to purchase full version of Practce Test

of Video Tutorials & to try practce test sofware for free:

http://www.testschamp.com/200-601.html

Mooey Back Guaeaotee