Desalter Inquiry
5
ELECTRICAL DESALTER UNIT Client: _______________________________ Date: ___________________________ Project: _______________________________ Contact: ________________________ Location: ______________________________ PSL Reference: __________________ 1. SITE CONDITIONS 1. ______________________ Ambient Temperature: F_____________ _________________________ Design Wind Speed - mph_____________ _________________________ Elevation - feet ASL _____________ _________________________ Earthquake Zone _____________ _________________________ 2. PROCESS DATA 2. ______________________ Crude Type Crude Gravity, API Crude Viscosity: @ O F @ O F 440 East Lake Road Airdrie, Alberta Canada T4B 2C3 P: 403.912.7000 F: 403.912.7011 E: [email protected] Page 1 of 5
description
desalter
Transcript of Desalter Inquiry
INQUIRY DATA SHEET
ELECTRICAL DESALTER UNIT
Client: _______________________________ Date: ___________________________
Project: _______________________________ Contact: ________________________
Location: ______________________________ PSL Reference: __________________
1. SITE CONDITIONS
1. ______________________
Ambient Temperature: F______________________________________
Design Wind Speed - mph______________________________________
Elevation - feet ASL______________________________________
Earthquake Zone______________________________________
2. PROCESS DATA
2. ______________________
Crude Type
Crude Gravity, API
Crude Viscosity:
@ OF
@ OF
Crude Rate, BPSD
Crude BS&W, Vol. %
Salt Content, ptb
Process Water Available:
Water Source
Rate Available
Chloride Content, ppm
pH Temperature, OF
Power Supply:
Volts
Amps
Hz
Product Specifications:salt out, ptb BS&W, Vol. %
INQUIRY DATA SHEET DESALTER
PAGE 2 OF 3
2.2Inlet Conditions
2.2 _____________________
Operating Pressure:
_________________________
- Minimum PSIG______________________________________
- Maximum PSIG______________________________________
- Normal PSIG______________________________________
Operating Temperature:_________________________
- Minimum F______________________________________
- Maximum F______________________________________
- Normal F______________________________________
3. MECHANICAL DATA
3. ______________________
3.1Design Conditions
3.1 _____________________
Design Pressure: kPag ______________________________________
Design Temperature F______________________________________
Vessel Corrosion
_________________________
Allowance: inches______________________________________
Piping Corrosion
_________________________
Allowance: inches______________________________________
3.2Instrumentation
3.2 _____________________
Pneumatic Controls:_________________________
Yes/No______________________________________
Instr. Gas______________________________________
Instr. Air______________________________________
Supply Pressure: KPa______________________________________
Electric Controls:
_________________________
Yes/No______________________________________
Voltage______________________________________
Utilities Available:
_________________________
Electric Power______________________________________
Voltage______________________________________
Phase______________________________________
Cycle______________________________________
Maximum Load KW ______________________________________
3.3Buildings
3.3 _____________________
Required: Yes/No______________________________________
Controls Only______________________________________
Total Skid______________________________________
3.4Size Limits:(Shipping)3.4 _____________________
Max. Height: ft.______________________________________
Max. Width: ft.______________________________________
Max. Length: ft.______________________________________
Max. Weight: lbs.______________________________________
440 East Lake Road Airdrie, Alberta Canada T4B 2C3
P: 403.912.7000 F: 403.912.7011 E: [email protected] 4 of 5
