Cut head parts on ALL solid lines. Pattern lines will be on INSIDE of face and back of head.
description
Transcript of Cut head parts on ALL solid lines. Pattern lines will be on INSIDE of face and back of head.
Cut head parts on ALL solid lines.
Pattern lines will be on INSIDE of
face and back of head.
It will look like this:
Write name in pencilnext to
Made by:
With ruler and pencil redraw all dotted lines
to score the paper.
It will look like this.
It will look like this.
It will look like this…
Bend paper along scored lines toward
INSIDE of head.
The next step is attaching the horse’s
mane.
Using glue stick, place glue on back tab of large pattern piece,
on outside of face.
Take black paper rectangle and place on
tab, covering front of face.
Bend tab back again on same fold line.
Re-glue same tab, this time on the black
paper.
Line up tab from front and back of
head, sliding ears
under the face.
Turn face away from you so nose is opposite your
tummy.
Inside of face will be showing.
Attach tabs together by
holding in place.
Staple twice to hold together
securely.
It will look like this from the inside.
Put glue on back tabs (on outside) of
back of head.
It will look like this.
Attach tabs under inside jaw on both
sides of head.
Put glue on triangular tabs near teeth.
Put tab underneath and press to secure.
Put glue on one side of tab at nose.
Staple on both sides
to secure.
With hole punch, punch nose holes on
each side of face near teeth.
Hair:
With scissors, snip hair as desired to create interesting
mane.
Lines can be thick, thin, zigzag, curved,
etc.
Eyes:
Using pre-cut eyes and a pencil, design horse’s
eyes.
Use a U-shape for the eyeball.
Refer to examples.
Redraw pencil lines of eye and fill in
pupil with Sharpie.
They might look like this.
Place glue on back of eye and attach eyes to face on both sides. Add
eyelashes or eyebrows as
desired.
Ears:
Using Sharpie, place a dot in center of
space closest to mane.
Put glue on section with dot.
Overlap outside bottom tab of ear
onto glued section to create
a 3-D effect.
Press until tabs hold.
It will look like this.
Hanging:
Using hole punch, put two holes at back of head, holding punch as far as it will reach from bottom of head.
Cut piece of string 12” long. Put thread ends
through holes from inside to outside.
Pull and tie with overhand knot.