Crash cushion SMA City
-
Upload
stefano-maria-caterino -
Category
Engineering
-
view
108 -
download
3
Transcript of Crash cushion SMA City
SMA City The most compact solution for the protection of fixed obstacles
in Urban Areas!
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
The Crash Cushion designed to protect fixed obstacles from impacts at 50 km/h.
SMA City
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
1
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
Exemples of fixed obstacles:
- Posts - Trees
- Pillars - Cusps
2
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
Other fixed obstacles:
- Concrete Kerb
- Works of Art
- Pedestrian Areas
- Fences
- Building edges
- Tunnel entrances
- New Jersey barriers
- Temporary barriers
- Pillars
3
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
Road Accident Statistics
3.543 Accidents 171 Death4.496 Injuries
The spill or heeling of the vehicle represents the second type of accident in single vehicles (9.2% of the total accidents).The impact against fixed obstacles belongs to this kind of accident.
The front-side impact is the case that occurs most frequently (23% of cases).
Impact against fixed obstacle
17.098 Accidents 724 Death21.396 Injuries
Spill or heeling
Data ACI –ISTAT 2012
4
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
The installation of the restraint systems is mandatory when the safety distance between the fixed obstacle and the outer edge of the roadway is not respected.
In this case the distance between the fixed obstacle and the carriageway is less than 1 meter.
5
Safety distance
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
The pictures below show the necessity of installation of a VRS in Urban Areas
The installation of VRS is a must!
6
In all these cases the distance between the fixed obstacle and the carriageway is so small that a specific VRS becomes mandatory.
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
SMA City: The solution The Crash Cushion specifically designed by Industry A.M.S. to protect fixed obstacles within the Urban Areas!
The performances of this system allow to protect the passengers from an impact until 50 km/h.
7
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
SMA City - Features Three main features of SMA City:
• Extremely reduced lenght
• Completely made of steel
• 80% reusable
8
740 mm
900 mm
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
The reduced lenght of the system allows the installation also in places where the space is limited.
This is why SMA City can be installed everywhere in the centre of the city for example in front of light poles, trees, pillars or roundabouts.
Ultra compact sizes
9
10
Right protection of the obstacles
OBSTACLE
Frontal view Top viewLateral view
SMA City can protect a fixed obstacle in order to avoid a fatal impact
No distance from the obstacle is required !
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
11
Example of installation of SMA City
Below you can see the pictures of SMA City installed on the SS 7 bis in the city Center of Casalnuovo di Napoli. The device has been installed in front of an obstacle which has been
impacted many times causing serious injuries to the passengers.
Front view Rear viewLateral view
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
Structure completely made of steel
Steel has the following advantages:
- respects the eco-sustainability criteria;
- is recyclable;
- resists to temperatures until + 80° and -
20° degrees;
- does not release debris after an impact.
12
The absorption of the energyThe kinetic energy coming from the impact is gradually absorbed by the system in order to avoid serious injuries for the occupants of the vehicle.
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved. 13
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
After the impact the cells can be replaced and the system can be reused.
80% reusabilityThe absorbing cells are the perfect system for the right absorption of
the energy during an impact.
14
Before the impact After the impact
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
For further information give a look at our website:
www.smaroadsafety.com
Follow us on:- Facebookhttps://www.facebook.com/SMARoadSafety- Twitterhttps://twitter.com/SMARoadSafety- Linkedinhttps://www.linkedin.com/company/SMARoadSafety
15
Copyright © 2014, Industry A.M.S. srl. All Rights Reserved.
Thank you for your attention! Industry A.M.S. SRLVia Dante Giacosa
Zona ASI sudMarcianise (CE)
Tel: +39 0823821560Email: [email protected]
16