CIRCUIT DESIGN AND EXPERIMENTAL RESULTS: SIMO...
Transcript of CIRCUIT DESIGN AND EXPERIMENTAL RESULTS: SIMO...
!"#$%&'()*+',-$./$01('1$ 39!
CIRCUIT DESIGN AND EXPERIMENTAL RESULTS:
SIMO BUCK
!"#$%&'()*+',-$./$01('1$ 40!
' Inductor current time-sharing among the M output branches
' Two main-switches MP and MN
' M load-switches SWi (SWi, i = 1, …, M)
' M control loops and error signals "i
"i = (Vset,i – Vout,i)
' Inductor #CCM
' Outputs #DCM
M. Belloni, E. Bonizzoni, E. Kiseliovas, P. Malcovati, F. Maloberti, T. Peltola, T. Teppo: "A 4-Output Single-Inductor DC-DC Buck Converter with Self-Boosted Switch Drivers and 1.2A Total Output Current” ISSCC 2008.!
!"#$%&'()*+',-$./$01('1$ 41!
' If #("1+"2 +"3+"4)>0 ( The whole system needs
more energy ( X1 (main) should
increase ' If #("1+"2 +"3+"4)<0
( The whole system needs less energy
( X1 should decrease
!"#$%&'()*+',-$./$01('1$ 42!
' If #"1-#("2 +"3+"4)>0 ( The first channel needs
more energy ( X2 (load1) should
increase ' If #"1-#("2 +"3+"4)<0
( The first channel needs less energy
( X2 should decrease
!"#$%&'()*+',-$./$01('1$ 43!
' H(s) #First-order zero-pole filter ' A #Gain
!"#$%&'()*+',-$./$01('1$ 44!
! Analog Processing
!"#$%&'()*+',-$./$01('1$ 45!
' 0.5!m CMOS Technology
' 5 Metal Levels
' 2 Poly Levels
' Active area 3.5mm x 3.8mm
!"#$%&'()*+',-$./$01('1$ 46!
Hanh-Phuc Le et Al.
ISSCC07
Young-Jin Woo et Al.
ISSCC08
Kyoung-Sik Seol et Al.
ISSCC09
Outputs 5 2 4 5
Converter Topology Boost Boost Buck-Boost
Supply Voltage [V] 2.5#4.5 2.7#4.5 2.3#5 2.5#4.5
Output Voltages [V] (4-Outputs) 5# 12
(1-Outputs) -12# -5
-4.8#4 0#(Vsupply-0.5) (3-Outputs) 2# 9.5
(1-Outputs) 6# 10
(1-Outputs) 8# 12
Inductor [!H] 10 10 4.7 + 1
Output Capacitor [!F] 4.7 10 10 10
Switching Frequency [MHz] 0.7 1 3 1
Total Output Current [A] 0#0.11 0#0.1 0#0.145
Single Output Currents [A] 0 #0.04 0#0.1 0 #0.05
Peak Power Efficiency 80.8% 80% 83%
!"#$%&'()*+',-$./$01('1$ 47!
Cross Regulation!
!"#$%&'()*+',-$./$01('1$ 48!
! Self boost snubber
!"#$%&'()*+',-$./$01('1$ 49!
!"#$%&'()*+',-$./$01('1$ 50!
!"#$%&'()*+',-$./$01('1$ 51!
CIRCUIT DESIGN AND EXPERIMENTAL RESULTS:
HIGH SWITCHING FREQUENCY
!"#$%&'()*+',-$./$01('1$ 52!
( A control based on a Voltage-To-Pulse (V2P) converter avoids the Op-Amp and comparator use: $ Very low quiescent current $ Circuit area reduction
M. Belloni, E. Bonizzoni, F. Maloberti: "High Efficiency DC-DC Buck Converter with 60/120-MHz Switching Frequency and 1-A Output Current"; ESSCIRC 2009, pp. 452-455.!
!"#$%&'()*+',-$./$01('1$ 53!
( The delay time between the CLOCK rising-edge and the OUT PULSES rising-edge depends on Verror:
( Avoid inverter stages shoot-through currents to decrease the dynamic power consumption.
!"#$%&'()*+',-$./$01('1$ 54!
!"#$%&'()*+',-$./$01('1$ 55!
( 0.18!m gate length CMOS process with 5-metals and 2-poly ( 1.2 mm x 0.76 mm active area ( 0.003 mm2 used for the current-mode and V2P control
!"#$%&'()*+',-$./$01('1$ 56!
!"#$%&'()*+',-$./$01('1$ 57!
Pow
er E
ffici
ency
[%]
!"#$%&'()*+',-$./$01('1$ 58!
Supply Voltage 2.2V#2.8V Output Voltage 0.5V# (Vdd-0.2V) Output Current 0#1A
Nominal Switching Frequency 60MHz Maximum Switching Frequency 120MHz
Inductor 36nH (18nH @ 120MHz) Output Capacitor 4.7!F
Max Output Voltage Ripple 10mV Peak Power Efficiency @ 60MHz 93%
Peak Power Efficiency @ 120MHz 88% Max Line regulation 10mV/V
Load Regulation @ 60MHz 20mV/V Load Regulation @ 120MHz 25mV/V
!"#$%&'()*+',-$./$01('1$ 59!
CONCLUSIONS
!"#$%&'()*+',-$./$01('1$ 60!
! Power Management for Portable systems enables: " High efficiency " Miniature solutions (all in package) " Multiple output single inductor
! Power Management for Microsystems " Is an emerging discipline " Will benefit from existing knowledge
# Digital # SiP # Power management for Autonomous Systems
!"#$%&'()*+',-$./$01('1$ 61!
Thank you!!!!
!"#$%&'()*+',-$./$01('1$ 62!
REFERENCES • S.K. Hoon, N. Culp, J. Chen, F. Maloberti: "A PWM Dual-Output DC/DC Boost Converter in a
0.13µm CMOS Technology for Cellular-Phone Backlight Application"; Proc. of the 31st European Solid-State Circuits Conf., ESSCIRC 2005, Grenoble, 12-16 September 2005, pp. 81-84.
• E. Bonizzoni, F. Borghetti, P. Malcovati, F. Maloberti, B. Niessen: "A 200mA 93% Peak Efficiency Single-Inductor Dual-Output DC-DC Buck Converter"; IEEE Int. Solid-State Circuits Conf. - Digest of Technical Papers, ISSCC 2007, San Francisco, 11-15 February 2007, pp. 526.
• M. Belloni, E. Bonizzoni, E. Kiseliovas, P. Malcovati, F. Maloberti, T. Peltola, T. Teppo: "A 4-Output Single-Inductor DC-DC Buck Converter with Self-Boosted Switch Drivers and 1.2A Total Output Current"; IEEE Int. Solid-State Circuits Conf. - Digest of Technical Papers, ISSCC 2008, San Francisco, 3-7 February 2008, pp. 444-445.
• M. Belloni, E. Bonizzoni, F. Maloberti: "High Efficiency DC-DC Buck Converter with 60/120-MHz Switching Frequency and 1-A Output Current"; 35th European Solid-State Circuits Conference, ESSCIRC 2009, Athens, 15-17 September 2009, pp. 452-455.
• E. Bordeaux: “Portable Power Management: A Holistic Perspective”; Intersil Corp., Technical white paper.
• Linear Technology: “Power Management for Portable Products – High Performance Analog Ics”, 10.2007.
!"#$%&'()*+',-$./$01('1$ 63!
• “Portable Design in 2009”; Portable Design, January 2009, RTC Group Publications.
• S. Dearborn: “Power Management in Portable Applications: Charging Lithium-Ion/Lithium-Polymer Batteries”; Microchip Technology inc., 2004, White paper AN947.
• M. Davidson: “Understanding Portable Applications Requirements to Improve System Performance”; Power Designer, No. 103.
• J. Falin: “Designing DC/DC Converters Based on SEPIC Topology”; Analog Applications Journal, Texas Instruments Inc., 4Q 2008.
• O. Trescases, W. Tung Ng, H. Nishio. M. Edo, T. Kawashima: “A Digitally Controlled DC-DC Converter Module with a Segmented Output Stage for optimized Efficiency”; Proc. of the 18th Int. Symposium on Power Semiconductor Devices & IC’s, ISPSD 2006, Naples, 4-8 June 2006, pp. 1-4.
• A. Yoo, M. Chang, O. Trescases, W. Tung Ng: “High Performance Low-Voltage Power MOSFETs with Hybrid Waffle Layout Structure in a 0.25µ Standard CMOS Process”; Proc. of the 20th International Power Semiconductor Devices and IC's, ISPSD 2008, Orlando, 18-22 May 2008, pp. 95-98.
• J.A. Paradiso, T. Starner: “Energy scavenging for mobile and wireless electronics”; IEEE Pervasive Computing, Jan.-Mar. 2005, Vol. 4, No. 1, pp. 18-27.