boosterplug installation triumph tiger sprint 1050€¢ Triumph Sprint 1050 ST • Triumph Sprint...
Transcript of boosterplug installation triumph tiger sprint 1050€¢ Triumph Sprint 1050 ST • Triumph Sprint...
Installation Model specific instructions
These instructions are a model specific add-on to the general BoosterPlug installation instructions. The general BoosterPlug installation instructions can be found in the “Downloads” section on the BoosterPlug.com website: http://www.boosterplug.com/shop/cms-downloads.html
For:
• Triumph Tiger 1050
• Triumph Tiger 1050 Sport
• Triumph Sprint 1050 ST
• Triumph Sprint 1050 GT
Installation Tips • Install the BoosterPlug module as per the general installation papers.
• The pictures below should help you locate the AIT sensor where the BoosterPlug is installed.
• Remove the seat (Yellow circle - Picture 1)
• Remove the plastic covers that surrounds the tank on both sides (Yellow circle - Picture 2)
• Lift the rear of the tank slightly to remove the fuel tube, vent tubes, and electrical connectors (Yellow circle - Picture 3)
• Remove the tank
• The red circle will show you the location of the AIT sensor
• Note: The BoosterPlug for the Tiger and the Sprint have a longer cable for the AIT connector than shown on our website—this is
just to let you relocate the square BoosterPlug box,as there’s not much room under the tank.
Pictures