Installation Model specific instructions

These instructions are a model specific add-on to the general BoosterPlug installation instructions. The general BoosterPlug installation instructions can be found in the “Downloads” section on the BoosterPlug.com website: http://www.boosterplug.com/shop/cms-downloads.html

For:

• Triumph Explorer 1200

Installation Tips • Install the BoosterPlug module as per the general installation papers.

• The pictures below should help you locate the AIT sensor where the BoosterPlug is installed.

• WARNING: Removing the gas tank on a Explorer 1200 is not easy. If you’re experienced with tools and know about bikes, just

go ahead, but this is not a good first DIY project. If you’re in doubt, ask your mechanic to install the BoosterPlug for you !

• Remove the seat (Yellow circle—picture 1)

• Remove plastic covers - 6 pcs. on each side !!! (Yellow circle—picture 2)

• Lift rear end of gas tank slightly to remove electrical connectors to the tank (Yellow circle—picture 3)

• Disconnect the two rubber tubes that balance the content of the gas tank (one pipe on each side)and plug the four outlets from

the tank to prevent it from emptying itøs content on the floor (Yellow circle—picture 3)

• Remove the gas tank.

• The red circle will show you the location of the AIT sensor.

Pictures