Installation Model specific instructions

These instructions are a model specific add-on to the general BoosterPlug installation instructions.

For:

• Triumph Tiger 800 (2010-2014)

• Triumph Tiger 800 XC (2010-2014)

• Triumph Tiger 800 XR/XRx/XRt (2015 and up)

• Triumph Tiger 800 XC/XCx/XCa (2015 and up)

Installation Tips • Install the BoosterPlug module as per the general installation papers.

• The pictures below should help you locate the AIT sensor where the BoosterPlug is installed.

• Remove the seat (Yellow circle - Picture 1)

• Remove lower plastic covers on both sides (Yellow circle - Picture 2)

• Loosen upper plastic covers on both sides no need to remove them completely.(Yellow circle - Picture 2)

• Lift the rear end of the tank - make sure you dont scratch the tank against the upper plastic covers - protect the tank with a clean

rag (Yellow circle - Picture 3)

• The red circle will show you the location of the AIT sensor

Pictures