8229JE(M) Home surveillance system
-
Upload
asiasourcing -
Category
Documents
-
view
248 -
download
6
description
Transcript of 8229JE(M) Home surveillance system
-5- -6-
FCC Information
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference;
(2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the
equipment.
EU Environmental ProtectionWaste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authority or retailer for
recycling advice.
Warnings The apparatus shall not be exposed to dripping or splashing
and that no objects filled with liquids, such as vases, shall
be placed on the apparatus.
Turn off the camera/receiver if the system is not in use.
The camera/receiver can only be completely disconnected
from the mains by unplug the adapter.
Do not cut the DC power cable of the apparatus to fit
with another power source.
Attention should be drawn to the environment aspects
of battery disposal.
Specifications
* Actual transmission range may vary according to weather,
location, interference or building construction.
* All specifications are subject to minor change without prior
notice.
Cam
era
Receiver
General
Item Value
Transmission Frequency
Transmission Power
Unobstructed Effective Range
Modulation Mode
Operating Temperature
Operating Humidity
Imaging Sensor Type
Picture Total Pixels
Minimum Illumination
Night Vision Distance
View Angle
Bandwidth
ISM 2,400 ~ 2,483 MHz
17 3dBm
300m (Max.)
GFSKO O O O
0 C ~ 50 C / 32 F ~ 122 F
15%~85%
CMOS
640 x 480
0Lux (IR ON); 5Lux (IR OFF)
5m (Max.)
3MHz
Spread Spectrum FHSS
Sound Detection Sensitivity
Consumption Current(Max.)
Power Supply
Dimensions(W x D x H)
Weight(About)
LCD Screen Type
Effective Pixels
Receiving Sensitivity
Consumption Current(Max.)
Battery Working Time
<-38dB
500mA
2.36TFT-LCD
480 (R.G.B) x 234
-80dBm
200mA
3 hours
Weight(About) 135 g
Power Supply
Dimensions(W x D x H)
5VDC
68 x 149 x 26 mm
5VDC
112 x 109 x 133mm
420g
O55
Version 1.1Please read this user manual carefully before using this product. Failure to understand operation procedures may result in injury.
Model: 8229JE
DIGITAL PAN-TILT-ZOOM HOME SURVEILLANCE SYSTEM
8. Adjusting Viewing Angle of Camera The direction pad key on the receiver acts as a remote control for the viewing angle of the camera. Usage is as follows: 1). Use the / keys to rotate the camera horizontally. The maximum angle of rotation is 270 degrees. 2). Use the / keys to rotate the camera vertically. The maximum angle of rotation in this direction is 120 degrees.
6. Zooming You can enlarge the picture seen on the receiver by two (2) times by pressing the zoom button once; press again to return to non-zoom mode.
Other Functions * Press the CTRL button once to turn off the LCD screen for sleep mode; press again to turn it back on. While in sleep mode, you will still be able to hear the sounds picked up by the microphone.* Hold the CTRL button for 3 seconds to rotate the image seen on the receiver by 180 degrees. this optional mode is useful for users who have installed their cameras upside down.
* You may connect the receiver to any display device with an A/V input for a larger, clearer picture.
7. Channel Looping Setup The receiver supports up to 4 cameras working at the same time. you could press and hold the ZOOM button on the receiver until appear "scanning...." to enable the automatic looping function. the channels are shown on the monitor/TV one by one every 5 seconds. Press and hold the ZOOM button on the receiver again to exit the looping function. You can also press the CHANNEL button to exit the looping function.
Packing List
Structure
Installation
-1- -2- -3- -4-
Volume Control
Brightness Control
* 8229JE = GD8229 (camera) + GD7615 (receiver)
2.4GHz Wireless Camera x 1
2.4GHz Wireless Receiver x 1
Power Adapter x 2
AV Cable x 1
Earphone x 1
Antenna x 1
Installation Diagram
Rotate Base
Lens
Built-in Microphone
Infrared LEDs
Power Switch
Power Jack
Channel Selector
Channel Sync
Antenna Plug
Channel SyncIndicator
Power Indicator
Camera
Adapter
Camera
Receiver Adapter Monitor/TV
AV Output
VCR
Receiver
3. Connect the provided power adapter to the power jack of the
receiver and an appropriate power source. Then slide the power
switch to the ON position.
1. Attach antenna to the antenna plug at the back of the camera
by screwing it in place. Then place the camera on a flat, stable
surface.
2. Connect the provided power adapter to the power jack and an
appropriate power source. Then slide the power switch to the
ON position. The power indicator will light up and the camera
will calibrate itself by automatically running through its full range
of motion.
Notes:
* This receiver can also work on battery power. Please load four
(4) AAA batteries into their appropriate slots at the back of the
receiver, with proper orientation as indicated on the battery
compartment.
* If the receiver is left unused for an extended period of time,
please disconnect it from the power adapter and remove batteries
if they have been installed.
4. Channel Synchronization
5. You may adjust brightness and volume to your desired level by
rotating the dials on the side of the receiver.
Battery Cover
Stand
Earphone Jack
Power Jack
A/V Output
Volume Indicator(from camera)
Antenna
LCD Screen
CTRL
Zoom
Volume Control
Brightness Control
Channel Button
Camera Lens Direction Pad
Power Switch
Channel Sync Indicator(the second Led )
Press and hold the Channel button on the receiver until the
channel sync indicator flashes, and then press once the Channel
Sync key on back of the camera during the indicator flashes
(about 8 seconds) on the receiver, at which point the channel
number displayed on the receiver should match the channel
selected on the back of the camera. You may now control the
camera with the direction pad on the receiver.