20485-1 Bluetooth Logger-Manual - Comark … Logger Operating Instructions for COMBT1 Charge your...
-
Upload
nguyenlien -
Category
Documents
-
view
223 -
download
0
Transcript of 20485-1 Bluetooth Logger-Manual - Comark … Logger Operating Instructions for COMBT1 Charge your...
Bluetooth LoggerOperating Instructions for COMBT1
Charge your data logger
Your data logger will arrive partially charged. For optimum performance, charge it for 24 hours before use until no battery symbol is displayed. Please use the USB cable provided.
The symbols below show the various battery states:
Battery OK/charged Battery low Battery charging
No symbol displayed Solid Flashing
Download and Install APP from the Google Play Store
The Comark Bluetooth Logger is programmed and stored data is viewed via the Comark Android™ Bluetooth App. There is no traditional PC software, all programming, downloading, interrogating and sharing of data is controlled by the App.
To install, search for Comark Bluetooth Logger on the Google Play Store on your phone and follow the instructions below to activate.
Operation of the App
Once installed, open the Comark Bluetooth Logger App by clicking on the icon on your phone or tablet.
A screen will appear if
Bluetooth is not activated
on your device. Click Yes
to turn Bluetooth on.
Continue with set up.
Swipe the screen left to
access the next dialog
screen.
Operation of the App (continued)
Pairing the App and the Data Logger
Changing the PIN code for your data logger
Each new Bluetooth Logger has the default Bluetooth PIN code of ‘1234’.
Should you wish to activate a new PIN code, click on the grey padlock icon in the top right hand corner of the screen.
Enter your new 4-digit code, then press and hold the blue lock button to save.
Note: If you have more than one Bluetooth Logger Comark recommends that the password on all is the same.
Press the button on
the logger to activate
Bluetooth and press scan
on the App.
When the connection
is established, click
continue.
Once the logger is found,
click on it to begin setup.
The default Home Page
for your data logger is the
current reading screen.
Swipe left to access the
control logger screen to
set up or stop the logger,
download logger or view
current status.
Setup Logger
Click on Setup Logger to reveal the setup
screen.
Click on the sections one by one until the setup
is complete.
Press Start to send the settings to the
Bluetooth Logger. Logging will commence and
the App will return to the Home Page.
Stop Logger/Download Data
Click the Stop Logger icon.
Click Yes to continue to stop the logger. In order to download the data
logging must be stopped.
At the help message, click Continue and the data will be displayed on screen
as a graph with a number of statistics at the bottom. (These may scroll off
the page depending on the size of the screen).
To restart logging, click on the left arrow at the top of the screen, return to
the Control Logger section, where you can immediately setup and begin
logging again.
Operation of the App (continued)
Viewing/sharing dataOnce data is downloaded you can view or share it.
The data may take a few seconds to package ready for sending.
To delete the downloaded data, click on the Trash icon at the top right of the
screen and follow the on screen instructions.
To share data click on the Share icon at the top right of the screen.
Viewing previous data
Historic data records can
be accessed via the Home
screen.
Swipe left on this screen
to bring up the list of
previous data.
Click on any of the
downloads to view/share
data.
HelpClick the menu icon to access the help section.
From here you can access help files or send Comark an email to request
advice or ask a technical question.
The local settings for the App on your phone or tablet.
Comark Instruments, 52 Hurricane Way, Norwich, Norfolk, NR6 6JB, United Kingdom. Tel: 0207 942 0712 Email: [email protected] © Comark Part No. 20485-1