2004 MAXIMA - Scosche · 2015. 10. 9. · NISSAN 2004 MAXIMA Images Radio Front Speaker Rear 1....
Transcript of 2004 MAXIMA - Scosche · 2015. 10. 9. · NISSAN 2004 MAXIMA Images Radio Front Speaker Rear 1....
-
+12V Constant =YELLOW
+12v Acc. Switched = VIOLET
-12V Chassis Ground = N/A
+12V Illumination =N.A
+12V Dimmer =RED/BLUE
Amp Remote =GREEN/WHITE
LF+ = WHITE
LF- = BLACK
RF+ =YELLOW
RF- = BROWN
LR+ = BROWN
LR- = BLACK/BROWN
RR+= BLUE
Dash Type :
Kit:Harness:Antenna Adapter: N/A
Interface Adapter(s):
About the Vehicle
Make: NISSAN
Model: MAXIMA
Year: 2004
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
1'' tweeter
Speaker Adapter : N/A
Factory Assembly : Plastic housing with (3) PHS screws
Rear
MAXIMANISSAN
2004
DIN
NN1498
NN03
RR- =BLACK/WHITE
Factory Assembly : Plastic housing with (3) PHS screws
NOTES
Front Pillar: Lower Door : 6.1/2" Midrange
Speaker Sizes
Bose system comes equiped with a 320 watt 8'' speaker system.
Dimensions:
Dimensions:
NOTES
Rear Deck : 6.1/2" speakers
OPTIONS
MP3 PLAYER ONSTARXM OR SIRIUS RADIODVD BASED ONSTARBOSE AUDIO SYSTEM
AMPLIFIER LOCATIONS: Located in the rear deck, in the trunk.
Aftermarket Kit: SINGLE DIN
-
NISSAN2004 MAXIMA
Images
Radio
Front Speaker
Rear
1. Using a panel removal tool pop out the trim panel under the door handle.2. Remove (2) 10mm bolts from behind this panel.3. Using a pick tool pop out the screw cover behind the door openerand remove the screw.4. Using a panel removal tool pop out the power window switch. Disconnect and remove.5. Using a panel removal tool pop out the door panel and pull upward. Disconnect and remove
1. Using a panel removal tool pop out the trim panel under the door handle.2. Remove (2) 10mm bolts from behind this panel.3. Using a pick tool pop out the screw cover behind the door openerand remove the screw.4. Using a panel removal tool pop out the power window switch. Disconnect and remove.5. Using a panel removal tool pop out the door panel and pull upward. Disconnect and remove.
Radio Removal
Front Speaker
Rear speaker
1. Unscrew the shifter knob base & push down. Carefully remove cotter pin securing top portion of shifter knob then lift knob up & away. Lift up shifter knob base & away.2. Using a panel removal tool, pop out the shifter panel, disconnect & remove. Extract (2) Phillips head screws from behind.3. Using a panel removal tool, pop out the radio bezel from bottom to top, lift away, disconnect & remove. Extract (4) Phillips head screws from behind, securing radio.4. Using a panel removal tool, carefully unsnap the navigation/data screen panel, lift away, disconnect & remove. Extract (2) Phillips head screws from behind, securing radio.5. Lift away radio assembly, disconnect & remove.
Front Pillar
1. Using front speakerremoval instructions con-tinue by using a PRT and pop out the plastic housing, disconect and remove.