Summary

This is a scaled down version of the Rubber Duck made by Wille onThiniverse.

I have added a flat bottom and a hole for a 10*3mm magnet

It is recommeded to glue the magnet with some CA glue into the hole.

If your prints have an elephant foot inside the inner hole, take a sharpknive end remove the burr - then the magnet is press-fit

Household > Kitchen

fridgemagnet fridge duck

Unassociated tags: rubber duck

Category: Kitchen & Dining Print Settings

Rafts: Doesn't Matter Supports: No Resolution: 0,15 or better Infill:10% recommended

Notes:

Print in PLA, ABS, PETG or any other material. No infill needed, if the shellis at least 3 layers thick, otherwise us 10% infill.

WHerzog

Rubber Duck FridgeMagnets

VIEW IN BROWSER

updated 17. 11. 2019 | published 17. 11. 2019

3D M

ODEL

ONLY

Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES

226.2 KBupdated 16. 11. 2019

2.2 MBupdated 16. 11. 2019

Find source .stl files on Thingiverse.com

The Author has not uploaded any G-codes.Try to search in User G-codes section or generate and upload yourown.

License

This work is licensed under a Creative Commons (4.0 International License)

Attribution

✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition

rubberduck25b_single.stl

rubberduck25b_10.stl