Y Rubber Duck Fridge Magnets - media.prusaprinters.org€¦ · fridgemagnet fridge duck...
Transcript of Y Rubber Duck Fridge Magnets - media.prusaprinters.org€¦ · fridgemagnet fridge duck...
Summary
This is a scaled down version of the Rubber Duck made by Wille onThiniverse.
I have added a flat bottom and a hole for a 10*3mm magnet
It is recommeded to glue the magnet with some CA glue into the hole.
If your prints have an elephant foot inside the inner hole, take a sharpknive end remove the burr - then the magnet is press-fit
Household > Kitchen
fridgemagnet fridge duck
Unassociated tags: rubber duck
Category: Kitchen & Dining Print Settings
Rafts: Doesn't Matter Supports: No Resolution: 0,15 or better Infill:10% recommended
Notes:
Print in PLA, ABS, PETG or any other material. No infill needed, if the shellis at least 3 layers thick, otherwise us 10% infill.
WHerzog
Rubber Duck FridgeMagnets
VIEW IN BROWSER
updated 17. 11. 2019 | published 17. 11. 2019
3D M
ODEL
ONLY
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
226.2 KBupdated 16. 11. 2019
2.2 MBupdated 16. 11. 2019
Find source .stl files on Thingiverse.com
The Author has not uploaded any G-codes.Try to search in User G-codes section or generate and upload yourown.
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition
rubberduck25b_single.stl
rubberduck25b_10.stl