Extrude from the plan drawn in AutoCad

Extrusion from plan create the massing.

The lourves are copy to the points of a divided line.

Extrusion from �rst �oor are move into the model.

Pipe along a curve to create handrail.

Extrusion is copied to create staircase

Extrude surface along curve to create I-beam.

The components are assigned layers.

The I-beams are split and group together.

The columns are split by the �oor.

Overview

Floor layer create by using boolean di�erence with the walls.

Wall layer extruded from plan

Steel frame and support layer

I-beam support below the cantilever.

Stair layer.

The I-beam surfave is drawn using polyline and extrude along a curve.

Glass layer.

Door layer

Sliding door.

Door with handle and frame which is create using o�set surface.

Door handle create using pipe and blend.

Lourves layer

Roof layer create using o�set curve before extrude surface

Contour layer create usng create surface and readjust using points on.

Overall model